Ametek PST-2000 Руководство - Страница 7
Просмотреть онлайн или скачать pdf Руководство для Испытательное оборудование Ametek PST-2000. Ametek PST-2000 12 страниц.
Печатать страницу7 General Test Procedure
Use the following table to find the section for the gauge you wish to test.
If, after testing according to the appropriate procedure, the gauge does not function as
described, replace it. If the gauge is functioning properly and is accurate, refer to the ap-
propriate AMETEK Dixson Product Information Note (PIN) for troubleshooting tips.
To test this gauge,
900 Series Speedometer
900 Series Tachometer
Fuel and Temperature
Gauges
Ammeter
Notes - You can obtain the Accuracy Tables and Product Information Notes
072-40236-B
Using the PST-2000 with Freightliner Trucks
See Section:
8
9
10
11
referred to in this document by calling our Product Support Depart-
ment or by downloading them from our website at
www.ametekdixson.com.
The PST-2000 cannot test voltmeter gauges. See AMETEK Dixson
Product Information Note 072-40287 for information about trouble-
shooting voltmeter gauges.
Important!
The PST-2000 cannot calibrate gauges. Do not set the tool to a par-
ticular frequency or resistance value and then check the pointer
position. Instead, use the tool to position the pointer as directed in
the procedure, note the value indicated on the tool and verify it
falls within the given frequency range listed in the Accuracy Table
referenced by that procedure.
When using the tool to position the pointer to full scale, the fre-
quency displayed on the tool corresponds to the values given in
the Accuracy Tables called out in these procedures and not with
other calibration charts and booklets.
PIN:
Gauge Identification
072-40283
Blue plastic housing, or
mounted in 6/7 instrument
cluster.
072-40284
Blue plastic housing, or
mounted in 6/7 instrument
cluster.
072-40289
2-inch metal housing, or
mounted in 6/7 instrument
cluster.
072-40288
2-inch metal housing.
Page 5 of 10