AIR GAP ET116-001 Инструкция

Просмотреть онлайн или скачать pdf Инструкция для Адаптер AIR GAP ET116-001. AIR GAP ET116-001 2 страницы. Reverse osmosis

Печатать страницу

CONFIGURATION – B

1. Knock out the plug inside the

disposal nipple by using a

hammer and flat screwdriver. Tap

away all edges of the "knock out"

plug until only a round hole

remains. (See Fig.5)

2. Remove all pieces of plug left inside the disposal after ensuring that the

power has been disconnected. Run fingers carefully around bottom

circumference of chamber to search for any hidden fragments.

(See Caution below)

3. Cut off the "wye branch" of the ET116-001 with a hacksaw. Use the grooved

"cut line" provided, then smooth away any burrs. (See Fig.6)

4. Follow instructions 5,6, & 10 of Configuration – A to

complete the installation. (Only the "cut branch" will be

used in instruction 6, discarding the leftover section of

adapter... See Fig. 7)

5. After reconnecting the power supply, test to see

that disposal is clear. Quickly turn switch on then off and

listen for sound of any fragments. If an obstruction is

heard, disconnect power and repeat instruction 2

above until disposal is clear.

CAUTION:

The installer is urged to exercise extreme caution whenever reaching hand

inside disposal. After confirming that power has absolutely been turned off

(and will stay off until job is done), use extra care that fingers are not cut on

any sharp surfaces. Also, caution should be taken to avoid "over-tightening"

screw type hose clamps.

AVOID SIPHONING RO reject water into dishwasher.

(See important details below)

IMPORTANT:

The ET116-001is designed to be used downstream of an approved airgap

faucet and dishwasher airgap (when installed in conjunction with a dishwasher).

Most dishwashers have a built-in check valve, but these often fail. Some States

require the installation of a manufactured dishwasher airgap, while other states

permit the drain hose to loop up from the dishwasher to the underside of the

sink before descending to the disposal (See Fig. 3). Do not install a ET116-001

(with dishwasher) in the absence of one of these types of airgaps – use a

ET109-001 or ET112-001.

NOTE: To connect a reverse osmosis reject

MADE IN USA

Serving the

Reverse Osmosis

Water Treatment Industry

592 Apollo Street, Brea, California 92821 USA • 949-955-3928 • Email: [email protected]

Installation (without Dishwasher)

FIG. 5

Cut here

water drain line to the plumbing of a

single or double compartment sink

without a disposal, please request a

ET112-001.

FIG. 6

Model:

DRAIN LINE ADAPTER

FIG. 7

Part No.

ET116-001

(D-25QC)

Doc. # 400-0724-002

ET116-001

( DLA-D )

Pat. No. 5,635,058

MADE IN USA

Reverse Osmosis

For Disposal Connection with or

without Dishwasher

Brea, California