Flying Industry Development 0020423 Краткое руководство - Страница 2

Просмотреть онлайн или скачать pdf Краткое руководство для Приемник Flying Industry Development 0020423. Flying Industry Development 0020423 3 страницы. Rf wireless receiver

Печатать страницу
Press the transmitter: Turn on the relay, terminal OUT 1 outputs DC power, the lamp is turned on.
Press the transmitter again: Turn off the relay, terminal OUT 1 stop outputting, the lamp is turned off
Setting control mode Momentary: Only connect Jumper-1.
Control mode Momentary (with the transmitter C-1): Press and hold -> On; Release -> Off.
Press and hold the transmitter: Turn on the relay, terminal OUT 1 outputs DC power, the lamp is turned on.
Release the transmitter: Turn off the relay, terminal OUT 1 stop outputting, the lamp is turned off
Setting control mode Latched: Disconnect Jumper-1 and Jumper-2.
Control mode Latched (with the transmitter C-2): Press button 1-> On, other relays Off; Press button 2 -> Off.
Press button 1: Turn on the relay, terminal OUT 1 outputs DC power, the lamp is turned on.
Press button 2: Turn off the relay, terminal OUT 1 stop outputting, the lamp is turned off
Wired control terminals:
The receiver has wired control terminals, you can connect external devices, sensors, limit switches or manual switches to trigger the receiver.
1) By low level signal:
You can connect external devices (with low level output signal) to trigger the receiver.
When external device outputs low level signal to terminals 1 (Signal +) and terminal 3 (Signal -), terminal of OUT 1 output DC power, and the lamp is
turned on.
When external device stops to output signal, terminal of OUT 1 stop outputting, and the lamp is turned off.
2) By NO/NC contact:
You can connect manual switches (with NO/NC contact) to trigger the receiver.
When connect terminals 1 and 3 by manual switch, terminal of OUT 1 output DC power, and the lamp is turned on.
When disconnect terminals 1 and 3 by manual switch, terminal of OUT 1 stop outputting, and the lamp is turned off.
How to pair the transmitter to the receiver:
1) Press the learning button of receiver for 1- 2 seconds; signal LED on the receiver is on. The receiver enters into status of LEARNING.
2) Press any one button on transmitter. If signal LED flashes quickly 15 times and turns off, it means learning is successful.
3) When receiver is in the status of LEARNING, press again the learning button, signal LED turns off, learning process will be discontinued.
4) The receiver can learn several remote controls with different codes.
Delete all transmitters:
We have learned remote control to the receiver. If you don't want the receiver to work with the remote control, you can delete all codes of remote
controls, which are stored in the receiver.
Operation: Press and hold the learning button of receiver until signal LED flashes slowly; release the button, LED keeps slow flash. That means all
stored codes have been deleted successfully.
SHENZHEN GUIYUAN INDUSTRY DEVELOPMENT CO.,LTD
Http://www.carymart.com