AIR GIZMOS Panel Dock 795 Давайте начнем - Страница 2

Просмотреть онлайн или скачать pdf Давайте начнем для Док-станция AIR GIZMOS Panel Dock 795. AIR GIZMOS Panel Dock 795 2 страницы.

Step 4:

Verify the look and function of the mount

Step 5:

Mark the holes for drilling

Step 6:

Drill the holes

Step 7: Mount the Panel Dock using the supplied hardware

Step 8:

Install the provided Mounting Bracket into the Panel Dock

Step 9:

Insert the GPS and attach cables

Congratulations! Your installation is complete. Please email us with any questions you might have at

1100 Jupiter Road, Suite 110, Plano, TX 75074 • (972) 671-8001 tel • (972) 231-3870 fax

With the Panel Dock secured with the edge clamps you can verify that it is at the correct

depth and fits to your liking.

Remove one edge clamp at a time and mark the position of each hole with a pen. Use a

circular motion to mark the outer edges of the hole. This will make it easier to determine

the exact center.

Do this for all four holes, replacing the edge clamps as you go.

There are a number of ways in which you may choose to drill the holes. You can remove

the rails from the panel and drill them on a drill press, or you may use an angle drill to drill

them in the plane. Just be careful to make accurate holes at the marks you made, and

you will be fine.

The bolts we provide have an integral washer on the screw-head side. This provides

adequate distribution of force on the plastic to keep it from cracking. Position the hard-

ware so that the screw head is located on the plastic side and the nut is on the outer side

of the metal rail. Please, be sure not to overtighten the screws, it may result in cracking of

the plastic of the Panel Dock.

Vent Tube: Vent tube can be plumbed for an avionics cooling fan.

Using the 4 sets of screws and nuts, attach the bracket to the inside of the Panel Dock. Tight securely but do

not overtighten the screws - it may result in cracking of the bracket. Important: Test the release mechanism

before installing the GPS unit. The correct position of the mounting bracket is essential for proper operation

using the release lever and GPS power switch. If the mounting bracket is too low it can be difficult or impossible

to engage the bracket release mechanism and if too high it may cause inadvertent pressing of the power switch.

Note:

Alternatively, for this step you can use the Bracket and Docking Cable that are supplied from Garmin.

The Garmin cable is required if you wish to attach power or data connections to your GPS. If you decide to

do so, make sure to remove rubber grommets from the mounting holes before installing Garmin bracket.

If grommets are not removed the bracket will not be tightened securely.

To install your GPS into the dock, gently snap it into place in the Mounting Bracket.

On/Off / Brightness lever (top): Turn the aera 796 GPS on/off and adjust brightness of

Release lever (bottom): To release the GPS, press the down the lever and pull the

the screen while the unit it in the Panel Dock.

GPS out of the Panel Dock.