Astro Tool 612596 Краткое руководство по эксплуатации

Просмотреть онлайн или скачать pdf Краткое руководство по эксплуатации для Инструмент для обжима Astro Tool 612596. Astro Tool 612596 2 страницы. 8-step adjustable crimp tool connector assembly tooling

Печатать страницу

B A Y O N E T S O C K E T

GENERAL

The Astro Tool 612596 8-step crimp tool is a

cycle controlled, precision crimp tool capable of

crimping wire barrel sizes 20 to 28. This tool meets

the performance requirements of M22520/34-01 and

MS3198-1.

All Astro tools are designed to comfortably fit in

your hand for less fatiguing hand operation.

Observe the precision ratchet action by opening and

closing the tool several times. Note that the tool

cannot be opened without fully completing the

crimp cycle.

BASIC TOOL OPERATION

NOTE: For proper crimping, the Basic Tool must

be used with an appropriate Positioner Assembly.

1. Select the proper Positioner for the contact to

be crimped.

2. Place the Positioner in the Bayonet Socket.

Line up the pins on the Positioner with the slots on

the Bayonet Socket. Depress the Positioner and

rotate 90° clockwise and release. The Positioner

will then be locked in place.

ASTRO TOOL CORP.

CONNECTOR ASSEMBLY TOOLING

612596 8-STEP ADJUSTABLE CRIMP TOOL

(NSN 5120-00-833-4190)

S E L

N O .

A D JU S T M E N T K N O B

3. Consult the Data Plate on the face of the

Positioner for the proper selector setting. Grasp the

Adjustment Knob; raise and rotate until the proper

selector setting is lined up with the arrow on the

Top Handle. Release the Adjustment Knob.

4. Insert the contact through the Indenter

Opening and into the Positioner.

5. Insert the wire into the contact. Squeeze the

handles until the Tool comes to a positive stop.

Release the handles and the tool will return to the

full open position.

6. Remove the completed crimped assembly.

GAGING INSTRUCTIONS

Gaging the tool requires Astro Tool part number

621070 (MS3199-1) gage pin assembly.

1. Set the tool to selector setting # 8.

2. Close the handles to the fully closed position.

3. Holding the tool closed, insert the GO pin into

the indenter opening as shown, see figure # 1 The

gage must pass freely between the indenter tips.

4. Holding the tool closed, insert the NO GO pin

into the indenter opening. The gage pin must NOT

go between the indenter tips.

5-21-15 TI596-93-1