FlyingThingZ M1A1 Flying Tank Руководство по сборке - Страница 5
Просмотреть онлайн или скачать pdf Руководство по сборке для Игрушка FlyingThingZ M1A1 Flying Tank. FlyingThingZ M1A1 Flying Tank 20 страниц. A sport scale flying military tank
Печатать страницу
3 2.5" to 3" Wheels
Motor Mount and Mounting Hardware
2' Medium Fuel Tubing
Prop Suited to Engine
2" Filament Strapping Tape
Engine - .40 to .60 two-stroke or .45 to .72 four-stroke
Rubber Foam
Low Temperature Covering Material
Thin, Medium and Thick CA
5 minute and 30 minute Epoxy
CA Accelerator
White or Carpenter's Wood Glue
Small Square
#120, #220, #320 Sand Paper
Sanding Block
Hobby Knife with Extra #11 Blades
Pen, Pencil or Marker
Assorted Screw Drivers
Building Pins
Razor Saw
Miter Box
Masking Tape
Clamps or Clothespins
Wire Cutters
Unless a specific glue is specified, use your best judgement when joining parts.
CA WILL EAT FOAM. DO NOT USE CA TO BOND ANY PARTS TO FOAM.
Most of the tools listed herein come in handy when assembling parts provided by this kit. Although they are not all necessarily
required, they do make the process easier. You may substitute tools and other equipment listed here as long as they serve the same
purpose in a similar fashion.
Additional Kit Contents (Not Shown)
Part Description
3/4" x 4-40 Bolts
4-40 Blind Nuts & Washers
Landing Gear Straps
Nose Gear Hardware
#2 x 9/16 Wood Screws
5/32" Wheel Collars
Additional Kit Requirements
FlyingThingZ Pre-cut Self Adhesive Vinyl Covering
Clear Packing Tape
4 2-56 Pushrods
8oz. Fuel Tank
2" Spinner
4 Channel Radio with Elevon Mixing
3M Super 77 Spray Adhesive
Required Tools and Adhesives
Needle Nose Pliers
Scissors
Wax Paper
Paper Towels
Ruler
Mixing Sticks
Threadlock
Denatured Alcohol
Rotary Tool or Dremel
Router Attachment for Rotary Tool or Dremel
Rubber Bands
Dead Center Engine Mount Locator
Hex Wrench Set
Drill Bits (1/16" 3/32" 1/8" 5/64" and 1/2" bits)
Electric Drill
Qty.
1
1
4
1
2
6
5