Asus A8AE-LE Amberine Руководство пользователя - Страница 14

Просмотреть онлайн или скачать pdf Руководство пользователя для Материнская плата Asus A8AE-LE Amberine. Asus A8AE-LE Amberine 18 страниц.

3. Serial ATA connectors (7-pin SATA1, SATA0)

These next generation connectors support the thin Serial ATA cables for

primary internal storage devices. The current Serial ATA interface allows

up to 150 MB/s data transfer rate, faster than the standard parallel ATA

with 133 MB/s (UltraDMA133).

A8AE-LE

A8AE-LE SATA connectors

4. IDE connectors (40-1 pin IDE1, IDE2)

This connector supports the provided UltraDMA100/66/33 IDE hard disk ribbon

cable. Connect the cable's blue connector to the primary (recommended) or

secondary IDE connector, then connect the gray connector to the UltraDMA100/66/

33 slave device (hard disk drive) and the black connector to the UltraDMA100/66/

33 master device. It is recommended that you connect non-UltraDMA100/66/33

devices to the secondary IDE connector. If you install two hard disks, you must

configure the second drive as a slave device by setting its jumper accordingly.

Refer to the hard disk documentation for the jumper settings. BIOS supports specific

device bootup. If you have more than two UltraDMA100/66/33 devices, purchase

another UltraDMA100/66/33 cable. You may configure two hard disks to be both

master devices with two ribbon cables – one for the primary IDE connector and

another for the secondary IDE connector.

1. Pin 20 on each IDE connector is removed to match the covered hole on the

UltraDMA cable connector. This prevents incorrect orientation when you connect

the cables.

2. The hole near the blue connector on the UltraDMA100/66/33 cable is intentional.

A8AE-LE

A8AE-LE IDE connectors

ASUS A8AE-LE (Amberine/AmberineM) Motherboard

SATA1

SATA2

GND

RSATA_TXP2

RSATA_TXP1

RSATA_TXN1

RSATA_TXN2

GND

RSATA_RXP1

RSATA_RXP2

RSATA_RXN1

RSATA_RXN2

GND

NOTE: Orient the red markings

(usually zigzag) on the IDE

ribbon cable to PIN 1.

PIN 1