Dorex DX2 FC Руководство по установке - Страница 6
Просмотреть онлайн или скачать pdf Руководство по установке для Система открывания дверей Dorex DX2 FC. Dorex DX2 FC 12 страниц.
Печатать страницу03. PREPARE DOOR FOR DEVICE AND
TOP & BOTTOM LATCHES
1. Make the required cut-outs on the interior side of the door
for the exit device as indicated on page 4.
2. Make the required cutouts on the exterior side of the door
using the trim template or door preparation and installation
instructions.
3. Prepare the top and bottom edges of the door for the
latches using the Latch Mounting Preparaton information
on page 4.
05. ATTACH RODS TO LATCHES
Door
Interior
side
Top
Latch
Top Rod
Screw holes facing
center case.
Thread rod onto latch stud until screw holes on
rods face the center case
Outer edge latch bracket can be removed to
accommodate narrow door stile preparations
for Panic Deivces.
Screw holes facing
center case.
Bottom Rod
Bottom
Latch
04. DRILL TOP OF DOOR FOR RELEASE PLUNGER
Stop Height
¹⁄2"
⁵⁄8"-Std.
³⁄4"
Measure "Stop Height of Door Frame" to decide
"Dimension of A".
L C
of Latch
(Interior face of door)
RHR shown
LHR opposite
06. INSTALL RODS AND LATCH
Top Rod & Latch
Interior side
Latch Screws
Bottom Rod & Latch
Door interior
D
Latch Screws
1. Install top latch and latch screws at top of door.
2. Install bottom latch and latch screws at bottom of door.
3. Fine tune the overall rod length by threading the rods in and out
of the latches
6 / 12
Door Frame
Stop Height
³⁄8
"
A
¹¹⁄16"
¹³⁄16"
¹⁵⁄16"
Top of Door
A
Drill ¹⁄2" x ³⁄8" deep
Interior Face of Door Only.
SIDE VIEW
1¹³/16"
D
1¹³/16"
side
NOTE:
Cut top rod if necessary.
See page 11.
End of
Top Rod
L C
of Device
End of
Bottom
Rod