Daessy DSAM4 Инструкция по сборке Руководство - Страница 5

Просмотреть онлайн или скачать pdf Инструкция по сборке Руководство для Инвалидное кресло Daessy DSAM4. Daessy DSAM4 6 страниц. Swing aside mount

Swing Aside Mount Assembly

DSAM4

Setting the Swing Aside Direction

The DAESSY Swing Aside Mount is shipped with the Rotate Head setup

for installation on the Right side of a wheelchair. If necessary follow the

below steps to change for Left side installation.

Remove the center bolt from the blue direction pin.

Remove the pin, rotate it 180° until the diamond (◊) is positioned under the

'L', re-insert the pin.

Reinstall the center bolt and tighten snug but not too tight.

The Swing Aside Rotate Assembly has three

lock-pin position holes around the silver collar.

The mount is shipped with the attached tube

positioned with the lock-pin in the center

position hole; this is the "in-use" position.

Remove the packing material from the tube hole

retaining the Pinch Clamp. Be careful not to

lose the Pinch Clamp.

Slide the Assembly onto the top of the Vertical

Tube. The Pinch Clamp must be aligned in its

hole so that it is even with the inside of the tube

hole to allow the tube to slide through

completely. Gently tighten the Pinch Clamp bolt.

Adjust the positioning of the Assembly so the lock-pin position holes

are oriented with one facing forward, one towards the inside of the

wheelchair, and one facing rearward. The assembly is shipped such

that this will position the horizontal tube across the chair ("in-use"

position).

Tighten the Pinch Clamp bolt firmly.

Printed in Canada

Manufactured by Daedalus Technologies in Canada

www.daessy.com

Page 5 of 6