bolid S2000-SP1 ORION ISS Руководство по установке - Страница 3
Просмотреть онлайн или скачать pdf Руководство по установке для Клавиатура bolid S2000-SP1 ORION ISS. bolid S2000-SP1 ORION ISS 8 страниц. Executive relay module
Также для bolid S2000-SP1 ORION ISS: Руководство по эксплуатации (10 страниц)
Печатать страницу3.1.9 Remove the module cover as shown in Figure 2.
3.1.10 Screw the woodscrews to the mounting holes and attach the module on the wall.
3.2 Mounting on a DIN-rail
3.2.1 Select the mounting place for the
module so that to provide free access to
1
the tapping screw at the upper end of the
module front cover.
Place the hooks
3
3.2.2 Install the module on the DIN-rail as
of the module
shown in Figure 3.
Turn it until
base under the
3.2.3 Remove the module cover as
clips onto
lower edge
shown in Figure 2.
of the DIN-rail
the rail
2
Slightly push on
the lower edge of
the module
Figure 3. Installing the module on the DIN-rail
4 CONNECTING THE MODULE
4.1 Connecting the RS-485 Interface Bus
4.1.1 Connect А and В lines of the RS-485 interface bus to "А" and "В" terminals of the
module respectively. Use wires with the cross section of no more than 1.5 sq. mm.
4.1.2 Unless the module is the last or the first device in the RS-485 interface bus, remove
the ХР2 jumper from the module PCB (see Figure 4).
4.1.3 If the module, the console or other Orion system devices connected to the RS-485
interface bus are supplied with power by different power supplies, couple their "0V" circuits.
4.2 Connecting Executive Devices
4.2.1 Connect normally open contacts of a relay ("NO" and "COM") to the circuits which
unauthorized closing is prohibited even upon power failures in the module (such as a shutoff).
4.2.2 Connect normally closed contacts of a relay ("NС" and "COM") to the circuits which
unauthorized opening is prohibited only in case of module's power failures.
4.3 Connecting Power Supplies
4.3.1 Connect the main power supply to the terminals "+U1" and "0V" of the module.
4.3.2 If necessary, connect the optional power supply to the terminals "+U2" and "0V" of the
module.
4.3.3 Please do not confuse the polarity connecting the module to the power supply
(supplies).
www.bolid.com
3
S2000-SP1 ver.1.56 INSTALLATION MANUAL rev.0