Boltek EFM-INV2 Руководство по установке - Страница 12
Просмотреть онлайн или скачать pdf Руководство по установке для Стойки и подставки Boltek EFM-INV2. Boltek EFM-INV2 13 страниц. Inverting mounting kit
Печатать страницу10/15/2020
Fiber optic assembly
The following instructions are for installing the fiber optic connectors. Orders placed with the
fiber optic upgrade will have the connector pre-installed. Refer to Exploded View of Assembly
section in this guide for part descriptions.
Loosen the bulkhead nut and slide it down the inverted mast along with the washer and
shroud.
The bulkhead nut is reverse threaded. Turn clockwise to loosen.
Remove the three case screws and slide the EFM-100 down from the cover.
Insert the small Molex connector into the junction box and feed through the mast until it
reaches the EFM-100 and insert the plug into the fiber optic header until it locks into place.
Wipe the inside of the junction box with alcohol swab then remove double sided tape backing and affix
to the inside. Insert fiber optic cable through the bottom of the junction box, with a large loop. Carefully
line up the key slot and wing tabs and insert cable into connector with a quarter turn.
(C) 2020 BOLTEK CORP
EFM-INV_Instruction_1.3