Air King 9842 Руководство по эксплуатации - Страница 3
Просмотреть онлайн или скачать pdf Руководство по эксплуатации для Вентилятор Air King 9842. Air King 9842 8 страниц. Air king 9842 fan: operating manual
Печатать страницуCAUTION:
MAKE SURE POWER IS SWITCHED OFF AT
SERVICE PANEL BEFORE STARTING INSTALLATION.
NOTE: If a light fixture is being installed with the fan, follow the
fixture's owner's manual for wiring. This fan is adaptable to center-
mount light kits only.
1.
Make sure the electrical box is properly secured. Connect the
White wire from the fan to the White wire from the supply.
Connect the Black and Blue wires from the fan to the Black
(hot) wire from the supply. Connect the Green (ground) wire
from the fan to the Green or Bare Copper ground wire from the
supply. Use approved methods for all connections. Carefully
push wires back up into outlet box (Figure 4).
Supply from home
Ground
from fan
Figure 4
SECTION 5
Securing the Motor
1. Swing motor bracket up to mounting bracket and secure in
place with the three screws removed in
Installing the Fan
(Figure 5).
Mounting
Bracket
Motor
Bracket
Figure 5
9842 Rev A. 9-05
Hot (Black)
White
Hot (Black)
Hot (Blue)
Step 1 in Section 3
Screws
www.airkinglimited.com
WARNING:
FAILURE TO COMPLETELY TIGHTEN THE SCREWS
COULD RESULT IN THE FAN LOOSENING AND POSSIBLE FAILING.
SECTION 6
Installing the Canopy
1. Remove the four canopy mounting screws and washers located
on the side of the mounting bracket (Figure 6).
Mounting
Bracket
Figure 6
2. Insert one of the screws and washers removed in Step 1 in side
hole of mounting bracket, being careful not to fully tighten. Leave
a minimum of 1/8" distance between the screw head and
mounting bracket. Locate the hole on the opposite side of the
first screw and insert the second screw, being careful not to
fully tighten. Leave a minimum of 1/8" distance between the
screw head and mounting bracket (Figure 5).
1/8"
Screw
Mounting Bracket
Figure 6
3. Raise the canopy up to the mounting bracket. Apply light pressure
upward on the canopy while rotating it to the right until the two
screws from Step 2 drop into the side hook slots in the canopy.
Make sure the washers are on the outside of the canopy and
continue rotation until the canopy is fully locked and stops
rotating (Figure 5).
Hole
Figure 6
4. Insert the last two screws and washers through the remaining
side holes of the canopy into the mounting bracket. Tighten all
four screws.
Side hook
Turn right to lock
Screw
Washer
1/8"
slot
3 of 8