Dafra DNP3212-2 Руководство по эксплуатации - Страница 5

Просмотреть онлайн или скачать pdf Руководство по эксплуатации для Заклепочные инструменты Dafra DNP3212-2. Dafra DNP3212-2 9 страниц. Rivnut tool

TO SET RIVNUTS

1) After start-up preparations, stroke setting and initial trial setting, to put the rivnut into work piece hole

(pre-drilled), to insert the cap screw of the tool into the rivnut and press the button of the tool, the

operation of the rivnut setting will be automatically finished.

2) The tool, after the button pressed, the tool will automatically insert into the rivnut and set the rivnut

on the work piece then released automatically;

3) If users have not had the stroke setting correctly, the tool might cannot be released, then follow the

process described below to release the tool:

a) Slightly press the release button at the rear of the tool;

b) Press the button of the tool, then the tool will be release from the set rivnut.

4) If the tool operator used a bad quality rivnut or improper stroke setting, the tool might be blocked on

the set rivnut and work piece and cannot be released according to the above 3) described, then to

use the anti-block sticker in the tool kit, insert into the slot-shaped hole on the nose sleeve, then

turning the tool with force anti-lock wise to release the tool.

TOOL MAINTAINANCE

Normally after several weeks of working, for better performance of the tool, to add a few drops of

hydraulic oil on the inlet of the air adaptor of the tool in order to reduce the fictions of the tool parts since

the oil will be blown inside the tool when tool operates.