Dotco 21D Series Руководство по эксплуатации - Страница 8
Просмотреть онлайн или скачать pdf Руководство по эксплуатации для Сверло Dotco 21D Series. Dotco 21D Series 12 страниц. .4 hp pistol grip
Печатать страницуPL32--21D
September 14, 2001
1008811 Spring Seat
•
1008810
Retaining Ring
•
1021296
Valve Assembly
Valve Disassembly
1. Remove Valve Assembly from tool housing by loosen-
ing Nut (part #1017585).
2. Remove small snap ring from rear end of assembly;
spring seat and spring will drop out.
3. Push in on trigger to force out the Valve Assembly (part
#1021296). Push Rod will now fall free.
4. Remove the two steel balls from the bushing by press-
ing against balls from the inner face of the bushing.
Parts Inspection
1. Check Valve Assembly (part #1021296) for wear. If
worn, replacement of this entire unit is recommended.
2. Check push rod for wear. Rod should have a firm, slid-
ing fit, free from excessive looseness.
•
(
) Indicates recommended spare part. Order one (1) or one set for every five (5) tools, or two sets for 6--10 tools. Small,
easily lost or low cost parts should also be ordered on the basis of 3--4 per 10 tools.
See also chart on Page 4.
BUCKEYE
21D--100 Series Drills
•
1005045 Spring
1021306
Idling Valve
1008695 O--Ring
•
1017586 Bushing
1008261 O--Ring
1021241 Throttle Valve
1018757 O--Ring
Valve Reassembly
1. Insert the two balls in the holes in the bushing. Hold in
place with a small amount of grease. Then, hold bushing
horizontally to keep balls from falling out.
2. Insert push rod into the bushing with small end toward
the back (larger end) of the bushing. Slide in far enough
to allow the balls to drop below the I.D. of the bushing.
3. Slip trigger over the bushing. Push trigger in; then, us-
ing a small pointed object, force push rod forward which
allows the two balls to ride up into the undercut area in-
side the trigger -- thus, locking the trigger in place.
4. Drop #1021296 Valve Assembly into the bushing, small
end of valve first.
5. Replace spring and spring seat with ridge of seat cover-
ing end of spring. Replace snap ring.
Page 8
Package Valve Assembly
•
Part Number
1024712
1005081 (3/32" Dia.) Steel Ball
(2 required)
1017585 Nut
1008913 Push Rod
1008248
Trigger
1008912 Ret. Clip