Doug Fleenor Design RERUN-R2 Руководство пользователя - Страница 6
Просмотреть онлайн или скачать pdf Руководство пользователя для Оборудование для звукозаписи Doug Fleenor Design RERUN-R2. Doug Fleenor Design RERUN-R2 12 страниц. Rackmount dmx512 recorder
Печатать страницу
THE ANATOMY OF A SHOW
The Rerun Rackmount has ten show memories each capable of recording 40 minutes of DMX512 data.
Within each show memory are non-destructive trim points called the START POINT and the END POINT.
The show memory is the data space used to store the show. Its time line always starts at the top of the
show memory (the point at which the [SHOW] button was pressed to begin recording). The show time line
continues until the bottom of the show (the point at which the [SHOW] button was pressed to stop
recording) or when the recorded show exceeds the show memory at 40 minutes. The START POINT is
the point at which your show will begin to playback when the [SHOW] button is depressed. The END
POINT is the point at which the show will end. By default when you record a show the START POINT and
END POINT are positioned at the top and bottom of the recorded show (Figure 1). The START POINT and
END POINT can be moved to any time within the recorded show allowing you to non-destructively trim the
show (Figure 2).
Figure 1
RECORDING SHOWS
In order to capture the individual channel levels recorded to a show, the Rerun Rackmount must be
connected to a DMX512 source. If DMX input is present on universe 1, the record mode can be started.
Recording a show with no DMX present on universes other than 1 causes DMX values of 0 to be recorded
in those universes. This applies to universes 2 - 4 only. It is recommended that your console output all 512
slots. When fewer than 512 slots are received a level of 0 will be stored for all slots above those received.
To allow you to observe the show being recorded the Rerun Rackmount echos data being received on its
output port.
Using the primary DMX512 console, go to the beginning of the show to be recorded.
1.
Depress the [RECORD] button located underneath the RED LED. The SHOW LEDs will begin to
2.
flash and the RECORD LED will illuminate. If you decide after depressing the [RECORD] button
that you do not wish to record a show, depress the [RECORD] button a second time. No changes
will have been made.
Depress the [SHOW] button underneath the show number you wish to record. The show will
3.
immediately begin recording. The SHOW LED will indicate the show being recorded and the
RECORD LED will flash.
Start running the show to be recorded on the DMX512 console.
4.
To stop recording, depress the [SHOW] button underneath the show number you are recording.
5.
Repeat steps 1 through 5 until you have recorded as many shows as desired, up to ten total.
Note:
!
If you have a Rerun Rackmount with multiple universes, every universe will be recorded once recording starts. DMX512
data must be present on the first universe to allow all additional universes to record.
Page 6 of 12
Figure 2