Doug's Headers D3300 Инструкции по установке

Просмотреть онлайн или скачать pdf Инструкции по установке для Автомобильные запчасти Doug's Headers D3300. Doug's Headers D3300 4 страницы. 92-96 corvette, 5.7 lt-1/lt4 this vehicle is equipped with

Печатать страницу

Corporate Office: PerTronix Inc. 440 E. Arrow Highway, San Dimas, California 91773 * Phone 909.599.5955 * FAX 909.599.6424 * www.dougsheaders.com

HEADER INSTALLATION INSTRUCTIONS

PerTronix

thanks you for choosing

to realize the full potential of our good fit, please read and understand these instructions completely prior to starting work.

CHECK TO MAKE SURE YOU RECEIVED THE PROPER PARTS FOR YOUR APPLICATION. THE HEADER NUMBER WILL

BE STAMPED ON THE ENGINE FLANGE. IF YOU ARE UNSURE YOU HAVE RECEIVED THE PROPER PARTS CALL

BEFORE YOU START WORK.

BE SURE TO WORK SAFE! WHENEVER YOU WORK UNDER THE VEHICLE BE SURE THAT IT IS LOCATED ON LEVEL,

SOLID GROUND AND IS SUPPORTED BY ADEQUATE SAFETY STANDS!

REMEMBER: HOT ASPHALT WILL NOT SUPPORT MOST JACK STANDS!

Many factors affect the installation of headers, some of which are broken or aftermarket motor mounts, accidents that impact the

configuration of the frame, and/or the installation of different engines or aftermarket cylinder heads. Most installations require

some welding. If you are uncomfortable with welding operations, we recommend that you contact a professional exhaust

system specialist to install your new headers.

Attention Customers breaking in new engines: Due to the extreme heat generated during the break-in process, the

appearance of the ceramic coating may be altered in certain areas. The protection characteristics and thermal barrier properties

of the coating is never compromised. It is recommended that a cast iron manifold or old set of headers be used for this process.

Notice: The coating of these headers can be marred or scratched during installation. If the header needs to be returned and is

damaged, you will be charged for recoat.

Disconnect the negative battery cable from the battery.

If a car lift is not available, raise the vehicle 2 feet or higher and support it with

adequate safety stands. Make sure the vehicle is on a flat solid surface and is stable.

Remove bolts from headpipe to exhaust manifolds.

Note the spark plug wire locations and remove them from the spark plugs. Use a

twisting motion while pulling the spark plug boot off of the spark plug. Be very careful

not to damage the spark plug boot and do not pull on the wire itself.

Remove spark plug wire looms, plugs and any brackets attached to the manifolds.

Part No. 0110-003061

Part # D3330

APPLICATION

92-96 CORVETTE, 5.7 LT-1/LT4

DOUG'S HEADERS

DISASSEMBLY / ASSEMBLY

Page 1 of 4

, the best fitting, highest quality header on the market. In order

REV3 3-5-13 DSL