Dahua F Series Краткое руководство по эксплуатации - Страница 12

Dahua HD IR Vari-focal Dome Network Camera Quick Start Guide

If the device needs to use WPS function, short press "Reset" button for 1~2 seconds when the



device is power on, press the WPS button of the router, generally the device can be connected to

the corresponding router within 1 minute (only supported by some models).

1. Find the Micro SD card slot and open the Micro SD card slot according to the direction shown in

Figure 2-4.

2. Adjust the direction of Micro SD card and install it into the installation slot.

3. Close the Micro SD card slot and lock the slot firmly.

Step 3

Fix the device on the installation surface

1. Take out the installation position map from the accessories bag and paste it on the installation

surface (ceiling or wall), dig three bottom holes for plastic expansion bolt according to the three

holes sites with cross sign on the installation position map, then insert three expansion bolts into

the installation holes and lock them firmly.

2. Adjust the device installation pedestal to the proper position and then pull cable through the exit

hole on Installation surface. Make direction of TOP sign same as it on installation position map.

Line up the three screw holes in the device pedestal to the three plastic expansion bolt holes in the

installation position, and then insert three self-tapping screws into the three plastic expansion bolts

and lock them firmly. Finally fix the dome body on installation surface.

Note:



If users adopt top outlet mode from installation surface when installing cable, you must dig an exit

hole on installation surface according to the installation position map.



If users adopt side cable outlet when installing cable, it must go through the U-shape channel on

dome pedestal, and take out cable from the side exit hole on pedestal.

Step 4

Adjust device monitoring direction, which is shown in Figure 2-5.

Figure 2-4