Amphenol PL18 30 Series Руководство по сборке - Страница 5
Просмотреть онлайн или скачать pdf Руководство по сборке для Кабели и разъемы Amphenol PL18 30 Series. Amphenol PL18 30 Series 9 страниц. G70-1pos powerlok 10mm g2 180d plug connector
Печатать страницу步骤4：取1pcs的 ③ R4 holder 自左端穿上线缆，并压接在其上(规格参照表4)
Step 4: Take a ③ R4 holder, load it to the cable end on the left, then crimp(refer to table 4)
③R4 holder
Crimp cable here
此处压接线束
Table 4：Contact and Conductor Crimping spec & retention force requirement
连接器
Connector
conductor area(mm²)
300/301 系列
300/301 Series
压接工具：油压机
Crimping tool : Hydraulic press
压模：L113130150D50
Die： L113130150D50
⑴
建议使用安费诺H+S线材（H+S线材型号详见步骤1-1），如果客户选用其它电缆，请联系安费诺业务，协商订制零配件
Recommend to use H+S cable. （See section 1-1 for details of H+S cable part numbers.） If you need to use customized cable, Please
contact local sales for product extentions
⑵
压接高度和拉拔力需要配合压接截面的金相分析，客户才能判断压接质量合格
Customers need to reconfirm cross section on crimping area and pull out force test to confirm the quality of crimp process
⑶
横截面仅供参考（其他举例：等边六变形的横截形状），客户负责采购压接工具或刀模
Cross section only reference tooling geometry (ex. hex and indent dimensions ),customer will take liability for sourcing tools or dies
步骤5：取1pcs的⑥螺旋弹簧安装在⑦外铜环上
Step 5: Take 1pcs ⑥Coil spring is installed on ⑦ Outer Copper Ring
步骤6：取2pcs的④锁块，将2pcs④锁块前端的台阶放置入端子和内皮之间的间隙
Step 6: Take 2pcs ④ lock housing, Place the front step of the 2pcs ④ lock housing into the space between
the terminal and the Insulation
Rev.01 20220225 Document No: 8P1161
表4：端子与线缆压接压接规格&拉拔力要求
导线截面积
Accepted cable OD (mm)
50mm²
④ Lock Housing
锁块
线缆外径
⑴
Crimping height (mm)
17.0±0.3
锁块缺口与端子止转面对齐
Gap of lock is in the same line with
the holder anti-rotation chamfer
Be sure the gap here is 2±0.5mm
确保这里的间隙是1.5mm到2.5mm之间
压接高度⑵
参考抗拉拔力
Retention Force
11.34 ±0.25
⑶
横截面
⑶
Cross section
⑥Coil spring
螺旋弹簧
⑦Outer Copper Ring
外铜环
⑵
2800N
04-07