Dovre 700 Инструкция по установке и руководство по эксплуатации - Страница 8
Просмотреть онлайн или скачать pdf Инструкция по установке и руководство по эксплуатации для Дровяная печь Dovre 700. Dovre 700 14 страниц.
Печатать страницу
ney can be heated up by lighting a ball of paper above the fire plate or at the back of
the bunker.
To kindle the fire in the stove you can use paper and/or fire-
lighters and small pieces of wood.
Slightly open the door and turn the air slide wide open.
It is important that the kindled fire should burn intensely. You
can then throw larger pieces of wood onto the fire, and close
the door. When the fire has eventually stabilized and is glow-
ing enough, you can put the logs or the brown coal briquettes
on the fire.
Make sure that the furnace door is always shut adequately.
Never stoke with an open door.
Add fuel timely. Do not add too much fuel at once. It is best to fill the hearth to
maximally one third and to add regularly.
Always open the filling door slowly and always open it for the shortest time possible.
Before adding, make sure that the charcoal base is distributed equally over the stok-
ing surface. If needed, open the primary
air valve for a little while.
If the wood is piled up loosely, it will
burn very quickly because the oxygen
will reach every piece of wood easily.
This piling is used when one wants to
stoke in a short time. When the wood is
piled more compactly, it will burn
slower as the air can only reach partic u-
lar pieces of wood. It is best to use this
piling method if one wants to stoke for
a longer period of time
Low intensity fires cause tar and creosote to deposit in the chimney after a long pe-
riod of time. Tar and creosote are highly combustible substances. Thicker layers of
these substances might catch fire when the t e mperature in the chimney increases
suddenly and steeply. Therefore it is necessary for the fire to regularly burn very
intensely, so that thin layers of tar and creosote immediately disappear.
Low intensity fires also cause tar to deposit on the stove panels and doors.
When it is not too cold outside it is better to let the stove burn intensely for just a
few hours a day.
4.3.
Low heating (for devices suitable for continuous use)
To use the device as a 'continuous fire', you can select the
primary and secondary air scoops in such a way you get the
right burning speed. Always make sure there's enough glow
on the heating bottom.
4.4.
Ash removal
With the included "cold" hand, the ashtray can be removed
from the appliance (see image). The ash drawer must be
timely emptied. The ashes must not obstruct the passage of
the combustion airflow, and in no case should the ash touch
the underside of the grating. If not, the grating will overheat
and will be damaged.
700
open stacking
8
compact stacking
03.27838.100