Amplificazioni Lombardi LCOMP2 Руководство - Страница 6
Просмотреть онлайн или скачать pdf Руководство для Компрессор Amplificazioni Lombardi LCOMP2. Amplificazioni Lombardi LCOMP2 13 страниц.
Печатать страницу1
3
1
mounting RACK
There are 4 holes in front panel for rack
mounting. The space within a rack is 2 units.
2
RATIO (rapporto)
Potentiometer to adjust in increments of
compression ratio, the numerical scale of
reference shows the different compression
ratios possible.
3
INPUT (ingresso)
Potentiometer to adjust the input volume, the
numerical scale of reference is figured in dB.
4
switch BYPASS (escluso)
This switch once and hold (with LED
"excluded" on) indicates that the channel is
excluded (bypass), then the input signal is
unchanged.
5
LED BYPASS (escluso)
The green LED (switched "bypass" down)
indicates the channel is excluded (bypass),
then the input signal is unchanged.
6
LED PEAK (picco)
The red LED indicates when the input signal
is too high
A M P L I F I C A Z I O N I
description of the front compressor
2
7
9
5 4 6
8
10
12
11
7
THRESHOLD (soglia)
Potentiometer for adjusting the compression
threshold, the numerical reference scale
ranges from 1 to 10. (increaseing this pot the
treshold is going down)
8
OUTPUT (uscita)
Potentiometer to adjust the output volume,
the numerical scale of reference is figured
in dB.
9
LED VU-meters
VU-meters or LED indicating the output level
or the level of compression.
10
switch output level / level compression
(liv. uscita / liv. compressione)
This switch lets you decide if the LED VU-
meters show the output level or the level of
compression.
11
control in channel "A" (controllo in A)
This switch pressed (with LED "control A"
on) indicates that the channel A and channel
B are governed by only channel A.
12
LED control in channel "A" (controllo in A)
This red LED when turned on (switch "control
A" down) indicates that the channel A and
channel B are governed by only channel A.
13
switch on/off (accensione / spegnimento)
Power switch ON and OFF.
13
page 6 of 13