AmpliVox Mity-Lite Plus SW320 Руководство пользователя - Страница 7
Просмотреть онлайн или скачать pdf Руководство пользователя для Динамики AmpliVox Mity-Lite Plus SW320. AmpliVox Mity-Lite Plus SW320 10 страниц. Battery powered pa system with bluetooth
Печатать страницу
WIRELESS PENDANT/BODYPACK MICROPHONE TRANSMITTER—Model S1678
Microphone Element
Headset S2045
FEATURES
BATTERY:
•
Microphone has a built-in rechargeable battery, the same as you have in your cell phone. A fully charged
battery should last up to 10 hours. Always keep your microphone fully charged. To be safe, when you see the battery
level has reached the last "BAR" of the battery symbol, recharge immediately.
POWER / MUTE BUTTON Y:
•
BLUE to show that it is "ON". Microphone will automatically sync with the receiver. If you wish to change channel, first
change to new channel on receiver and then press the power button once to activate the auto sync function.
To turn "OFF" press
button Y and release quickly. Button light will turn to RED. To unmute, press button again and
To MUTE, press
release quickly .
VOLUME CONTROL ADJUSTMENT Z:
•
during usage. Press SET, then press either up (+) or down (-) buttons to change volume level. There are only three lev-
els. Level is shown in LCD window when buttons are pressed. Additional volume adjustment is available on main control
panel. When used as a pendant microphone, start at level 3, set receiver level at 5 then adjust main volume. To prevent
squealing / feedback make sure that you are standing behind the speaker when talking.
LCD WINDOW 8:
•
Frequency Channel (1-16) and which receiver, "A" or "B" that microphone is transmitting to.
CHARGING INDICATOR 9
•
when fully charged.
AUX IN :
•
: Use microphone as a wireless transmitter for playing audio from other devices. You will need a cable that
has a 1/8" (3mm) on one end for connecting here and the other end will need to match the audio output connector of
your device.
NECK STRAP ;:
•
as show above. Slide strap buckle to adjust length. Push ends (click) together to close.
BODY PACK BELT CLIP <:
•
CHARGING CONNECTOR = :
•
Main Control Panel (see page 4) item H.
HEADSET a
•
: When used as a Body Pack Transmitter, connect optional headset S2045 here
9
8
Z
Y
a
and hold until you see "ON" appear in the LCD window U. Button will light
Press
button Y and hold until you see "OFF" in the LCD window. Release, button light will turn "OFF".
Shows battery level, HIGH - Three Bars / MEDIUM - Two Bars / LOW - One Bar;
: Located under the mesh, LED will turn RED to show that it is charging, turns GREEN
Adjust strap so that microphone is no more than 4 inches from chin. To open, pull apart connector
To remove, slide finger nail into crack (A) and lift up to release.
Locate 9 inch long cable that was in the accessory box of PA. Connect here and on
=
:
this feature allows you to change volume level, up / down of microphone
7
A
;
<
To charge battery, plug cable into
CHR.OUT on MAIN CONTROL
PANEL (see page 4) H
.