Advanced MxPro 4 Руководство - Страница 4
Просмотреть онлайн или скачать pdf Руководство для Оборудование для звукозаписи Advanced MxPro 4. Advanced MxPro 4 8 страниц. Shop interface unit
Также для Advanced MxPro 4: Руководство (10 страниц)
Печатать страницу
1 Installation
1.1 Installing the Mxp-014 in the Mx-4100/L
1.1.1 Mounting the Card
The card mounts on 4 pillars in the rear of the enclosure. See
diagram opposite.
Remove the gear tray assembly and set aside in a safe
place.
Screw in the four spacers supplied into the threaded inserts
in the back box. Use the four M3 screws supplied to securely
affix the card to the spacers.
Figure 1 opposite shows the location.
1.1.2 Internal Wiring
Use the supplied 10-way single in line ribbon cable to connect the input card, via the latched header – PL1, to
the 10 way latched header on the back of the display card (see Figure 4 for location on the display card).
NOTE: It will be necessary to disassemble the base card from the gear tray assembly to obtain access to this
connector. M3 nylock nuts secure the base card to the assembly – keep these safe for re-assembly.
The 8-Way Input Card requires a 24VDC Supply.
Connect the DC Input (see figure 6 for polarity) to the 24V DC AUX Supply Output on the base card as shown
in Figure 1. Run the cable along the rear wall of the back box and tie in place with cable ties. OBSERVE
POLARITY OF CONNECTIONS.
1.2 Installing the Mxp-014 in the Mx-4200/Mx-4400/Mx-4800
1.3 Mounting the Card
The card mounts on 4 pillars in the bottom left hand corner
of the control panel chassis adjacent to the Mx4200/Mx
4400 base card.
See diagram opposite.
Use the four M3 screws supplied to securely affix the card to
the chassis (the supplied spacers are not required).
It is not possible to install the Mxp-014 in this position if the
Mxp-029 Shop Interface is already installed.
PL
5
TB1
TB3
Base Card
DC 24V
Mxp-007
Figure 1
Figure 2
M3 Fixing Screws
PL
2
PL1
TB5
PL1
Mxp-014
DC 24V
M3 Fixing Points (x4)
Ribbon Cable
Input Card
Cable
www.advancedco.com