AmpliVox Presidential Plus SW-450 Инструкции по сборке - Страница 2

Просмотреть онлайн или скачать pdf Инструкции по сборке для Внутренняя отделка AmpliVox Presidential Plus SW-450. AmpliVox Presidential Plus SW-450 2 страницы. Lectern assembly featuring quickfit-expando 6 connectors

Печатать страницу

figure 2

figure 3

4. Attach front panel to left side. With the

left side panel laying on the work surface,

attach the front panel by sliding the connectors

over the steel pins. Both bottom unfinished

edges should be on the side. Use a phillips

screwdriver to tighten the 3 Quickfit-Expando 6

connectors.

Do not overtighten the connectors.

Over tightening can break the connectors.

[figure 3]

5. Install bottom panel. Place bottom panel in

the slot on the left side panel, flat unfinished

edge against the front panel. Using a phillips

screwdriver, install 4 Minibloc Screwpins through

the Minibloc holes into the predrilled holes in

the side panel. [figure 4]

6. Attach right side panel. Place the right side

onto the front and bottom panel, tighten the 3

Quickfit-Expando 6 connectors in the front panel

and install 4 Minibloc Screwpins in the 2

Minibloc connectors on the bottom panel.

Carefully

7. Install reading table and shelf. Slide reading

table over steel pins and tighten 4 Quickfit-

Expando 6 connectors. Slide shelf over steel pins

and tighten 4 Quickfit-Expando 6 connectors.

Install 2 locking casters on the finished side of

the bottom panel and 2 non-locking casters

using

the

Carefully stand unit up and install sound system

using amplifier instructions.

figure 4

Turn

1/2

turn

roll

unit

onto

front

#10

3/4

PPH

clockwise.

panel.

screws.