Comdel CPS-500AS Руководство по эксплуатации - Страница 4
Просмотреть онлайн или скачать pdf Руководство по эксплуатации для Портативный генератор Comdel CPS-500AS. Comdel CPS-500AS 12 страниц. Rf generator
Печатать страницуThe WARNING heading used in this manual explains dangers that might result in personal injury or death. Always
read the associated information very carefully before performing the indicated procedure.
The CAUTION heading used in this manual explains hazards that could damage the unit. Such damage may
invalidate the warranty.
MUST – This word is understood to indicate a mandatory condition.
HIGH VOLTAGE – Voltages greater than 50 volts DC or 25volts AC and known to cause death or serious injury if
contacted.
SERVICE – Any operation of maintenance, repair, calibration or similar activity other than the normal operation of
the unit.
QUALIFIED SERVICE TECHNICIAN, QUALIFIED ELECTRICIAN, QUALIFIED PERSONELL These terms indicate
persons specifically trained to install, service or other wise handle electronic equipment of the character and hazard
potential of this unit.
End User Labeling
The system installer should obtain and apply all appropriate safety and warning labels required by the end user's
local fire department jurisdiction and Occupational Health and Safety Administration over and above those supplied
by the generator manufacturer.
Read And Understand This Section Fully Before Installing or Operating This Equipment.
WARNING: This equipment must be installed, operated and serviced only by trained, qualified persons.
General Safety Requirements
•
WARNING: Hazardous Voltages and RF voltages are present inside this unit, which may cause injury or death.
To prevent electrical shock and or RF burns, never operate this equipment with the covers removed. Never
operate without an appropriate cable connected between the RF output connector on the rear panel and the
load.
•
CAUTION: There are no user or operator serviceable parts inside this equipment. Refer all service to a
qualified service technician.
•
This equipment must be bonded to Protective Earth (safety ground) prior to operating the unit. Safety ground
connection must be made at the unit's rear panel designated 1/4"- 20 threaded ground stud. The ground wire
should be a #14 awg or equivalent (minimum) green/yellow lead.
•
There is no reset required to restore operation after a shutdown due to over-temperature. If the cause of an
overtemp shutdown is to be investigated, primary power should be removed from unit or RF will restart as soon
as heat sinks cool below 75º C.
2