AMQ Activ Pro 2.0 Руководство по сборке - Страница 5

Просмотреть онлайн или скачать pdf Руководство по сборке для Внутренняя отделка AMQ Activ Pro 2.0. AMQ Activ Pro 2.0 20 страниц.

Печатать страницу

Safety Statement

RISK OF SERIOUS INJURY :

POTENTIAL FOR INJURY: The use of worksurfaces that do not comply with the AMQ deﬁned criteria and limitations

could cause personal injury or property damage due to pinch points, instability, or other problems.

POTENTIAL FOR NON-COMPLIANCE: The use of worksurfaces that do not comply with AMQ criteria VOIDS any

AMQ claims of compliance with ANSI/BIFMA, UL, LEED, or other applicable requirements. The use of non-AMQ

worksurfaces on AMQ adjustable-height bases may NOT be accepted as compliant to municipal electrical codes or

OSHA federal workplace standards, because this use does not create an NRTL (UL, ETL, etc.) listed product. AMQ is

not responsible for the ultimate determinations of compliance for height-adjustable bases with non-AMQ

worksurfaces. AMQ assumes NO liability for lack of standards compliance in these instances.

WARRANTY RESTRICTIONS: The use of non-AMQ supplied worksurfaces VOIDS all AMQ warranties, expressed or

implied.

DISCLAIMER: The use of non-AMQ worksurfaces is NOT recommended. Any use of a non-AMQ worksurface

requires additional investigation by the customer regarding the appropriate use. It is the sole responsibility of

the customer to determine the suitability and safety of the selected worksurface construction and attachment means.

The following information is provided as a guideline, but does not address all potential issues. Customers should seek

professional guidance as to the appropriateness of their chosen worksurface.

MANDATORY REQUIREMENTS REGARDLESS OF WORKSURFACE MATERIAL OR CONSTRUCTION:

FASTENERS: Adjustable-height bases include fasteners intended for use with AMQ worksurfaces.

These fasteners may potentially also be suitable for worksurfaces meeting the following criteria:

• Medium-density or higher particleboard or ﬁberboard cores with High-pressure laminate (HPL), Low-pressure

laminate (LPL) or veneer & backers

• Thickness of .984" (25 mm) or greater

• Fasteners located a minimum distance of .984" (25 mm) from any edge

Any other worksurface construction will require diﬀerent and/or additional fastening means and these means must

be determined by the project's designer, architect, or engineer. For example, solid-surface materials should use

appropriate threaded inserts and corresponding

fasteners or similar attachment means.

In all cases, all fastener locations provided in the

base attachment features MUST be used (e.g. if

attachment plate has 6 screw holes, all 6 holes

must be used for attachment).

FLAMMABILITY: Any worksurface or similar large

part> 10ft" 2 must have a ﬂame spread< 200

and a smoke developed index < 450 when tested

per UL 723.

SHARP EDGES: All accessible edges of the

worksurface must meet UL 1439 test for sharp

edges.

DIMENSIONAL LIMITATIONS:

• Worksurface depth not to exceed

30" (762 mm)

• Longitudinal worksurface position on cantilever

must be on centerline +/- 1/8" (3.17 mm)

• Worksurface overhang (distance from side

of support cantilever to edge of worksurface)

must be 1"+/-1/16"

• Maximum worksurface width may not exceed 72" (1828 mm)

FOLLOW ALL WARNINGS PROVIDED FOR BASE AND WORKSURFACE.

Activ Pro 2.0 Assembly Guide | 5

WARNING

WORKSURFACE

WIDTH

C L

WORKSURFACE

OVERHANG

WORKSURFACE

DEPTH

amqsolutions.com