DQ Vela Electric Руководство по эксплуатации - Страница 14
Просмотреть онлайн или скачать pdf Руководство по эксплуатации для Нагреватель DQ Vela Electric. DQ Vela Electric 18 страниц.
Также для DQ Vela Electric: Установка и крепление (4 страниц), Инструкции (2 страниц)
Печатать страницу
PAIRING USING THE REMOTE CONTROL
The SMART thermostat is equipped with two buttons: the Stand-by button and the
connection button.
Press the ON / Stand-by button to turn on the device or activate the "Stand-by" mode.
When the unit is ON, the setting mode and temperature are displayed.
FIRST USE AND PAIRING WITH THE REMOTE CONTROL
When no device is paired, the remote display will show the word "Conn" as long as at least one thermostat is paired.
CONNECTING THE FIRST DEVICE
While the word "Conn" is still on the screen, approach the stationary unit and press the Pairing button on the
chronothermostat, then press the [PROG] button on the remote control. The search symbol appears on the screen
until the thermostat is found, or 10 seconds elapse. If during this time the thermostat is not identified, repeat the
operation bringing the two devices together and making sure that the steps are correctly followed.
CONNECTING ADDITIONAL DEVICES
STAND-BY ----> CHRONO: to make the association, you must be in Stand-by and press the Chrono button for 5
seconds. Select with + & - PAIR on the remote control screen, then press the PROG button. By following the previous
steps, you access the '' Conn '' screen (see previous paragraph).
In this case, if you already have 8 units in memory, by pressing ON / OFF you can exit the "Conn" screen; if there are
already 8 fixed units in the memory, you will be asked which one to delete and replace with the new unit (for the
complete elimination of the selected thermostat, the new connection must be successful).
CHANGE THE THERMOSTAT TO MANAGE
The remote control manages only a thermostat at a time. To select another thermostat:
- From STAND-BY mode: press [Chrono] x 5 sec -----> Select SLCT with [+] & [-] and press [Prog] to confirm.
- From a different mode from Stand-by: [Chrono] x 5 sec ------> select the number of the device X with [+] & [-] ------
> Press [Prog] to confirm.
RESET
Delete all stored fixed units and reset the remote control to factory settings:
STAND-BY ----> CHRONO x 5 sec ----> select with + & - RSET on the screen ----- -> PROG.
The message RSET will flash on the screen. At this point, press again on the PROG key to confirm. Reset or press
ON / OFF button (or wait) to cancel. The thermostat returns to wait for the first connection.
BATTERY ICON
When the batteries are low, the battery icon will light up. The remote control can still be used, but it is better to use new
batteries. When the battery power is low, the word "BATT" will be displayed on the remote control and will stop working
until the batteries are turned off or replaced.
MADE IN ITALY