Electrolux 95G Буклет с инструкциями - Страница 4

Просмотреть онлайн или скачать pdf Буклет с инструкциями для Холодильник Electrolux 95G. Electrolux 95G 20 страниц. Gas and mixed fuel cookers
Также для Electrolux 95G: Буклет с инструкциями (20 страниц), Руководство по эксплуатации (24 страниц), Буклет с инструкциями (20 страниц)

Печатать страницу

Using the cooker hob

Control knobs on the gas hob

(Fig. 1)

The knobs for using the gas hob of the cooker are

found on the control panel. The regulation knobs could

be turned in anti-clockwise direction until the small

flame symbol, and vice-versa for the larger symbol.

No gas supply

Maximum gas supply

Minimum gas supply

Ignition of hob burners

To ignite a burner, before positioning the saucepan,

proceed as follows:

1. push the corresponding knob in completely

and turn in anticlockwise direction to the

maximum position;

2. upon ignition regulate the flame as required.

Mod. 95 G

1. push the relevant control knob in completely

and turn in an anticlockwise direction to the

maximum position;

2. press the ignition switch marked by a small

spark (

);

3. upon ignition regulate the flame as required.

In models provided with a safety device

("thermocouple", Fig. 2-D), the control knob must be

pressed in for approximately 5 seconds until the

safety valve automatically keeps the flame lit.

If after a few attempts the burner does not ignite, check

that the burner cap and crown (Fig. 2-A, B) are correctly

positioned.

To interrupt the supply of gas, turn the knob in a

clockwise direction to the position """.

In the absence of electricity, ignition can occur without

the electrical device; in this case approach the burner

with a flame, push the relevant knob down and turn it anti-

clockwise until it reaches the "maximum" position.

Leave the burners to cool before closing the

cover.

During cooking, when using fats or oils, take

particular care as they can, when over-

heated, self-ignite.

When switching on the mains, after installation or

a power cut, it is quite normal for the spark

generator to be activated automatically.

As soon as a liquid starts boiling, turn down the

flame so that it will barely keep the liquid

simmering.

Fig. 1

A - Burner Cap

B - Burner crown

C -Spark generator

D - Thermocouple

Fig. 2