Electrolux A01061201 Руководство по эксплуатации и уходу - Страница 7

Просмотреть онлайн или скачать pdf Руководство по эксплуатации и уходу для Холодильник Electrolux A01061201. Electrolux A01061201 20 страниц.

Печатать страницу

Door Handle

Mounting Instructions

Remove handle from carton and any

other protective packaging.

Position refrigerator handle end caps

over upper and lower pre-installed

shoulder bolts (A) that are fastened

into door, ensuring the holes for

the set screws are facing towards

the outside of door if a single unit

installation or the freezer door (if

installing the matching freezer)

While holding handle firmly against

door, fasten upper and lower Allen set

screws (B) with supplied Allen wrench.

Repeat steps 2 and 3 to install

freezer handle (if installing the

matching freezer). Ensure the holes

for the set screws are facing towards

the freezer door.

NOTE

All set screws should be tightened and

sub-flush (Allen set screw should be seated

just below the surface of the end cap) of

handle end cap. The end caps should be

drawn tight to door with no gaps.

Toe Grille Removal

To remove the toe grille, use a Phillips

head screwdriver and remove the two

screws holding the toe grille to the cabinet.

Then pull the toe grille away from the unit.

Leveling

•

The refrigerator must have all bottom

corners resting firmly on a solid floor.

•

The floor must be strong enough to

support a fully loaded refrigerator.

•

It is VERY IMPORTANT for your

refrigerator to be level in order to

function properly. If the refrigerator

is not leveled during installation,

the door may be misaligned and

not close or seal properly, causing

cooling, frost or moisture problems.

Installing Door Handle

Single Unit Installation

Ensure handle set screws

are facing each other

Matching Refrigerator and Freezer Door

Handle Installation

with doors closed

Toe Grille

Remove

Screws