Bosch 300 DLX Series Руководство по эксплуатации и уходу - Страница 28
Просмотреть онлайн или скачать pdf Руководство по эксплуатации и уходу для Посудомоечная машина Bosch 300 DLX Series. Bosch 300 DLX Series 40 страниц.
Печатать страницу
en-us Troubleshooting
Issue
Four vertical LED's (i.e. the cycle
duration indicators and the clean
indicator) are all flashing.
Dishware is not dry.
Silverware is not dry.
Appliance interior still wet after
wash cycle.
28
Cause and troubleshooting
There is a technical issue.
Press
.
1.
Pull out the power cord plug of the appliance or switch off the breaker.
2.
Wait at least 2 minutes.
3.
Insert the power cord plug of the appliance in a power outlet or switch on the
4.
breaker.
Switch the appliance on.
5.
If the problem occurs again:
6.
Press
.
‒
Turn off the water faucet.
‒
Pull out the power cord plug.
‒
Contact customer service → Page 34 and give the error code.
‒
No rinse aid used or dosage set too low.
Add Rinse aid → Page 14 .
1.
Set the amount of rinse aid to be dispensed.
2.
→ "Setting the amount of rinse aid", Page 14
Cycle or cycle option has no drying phase, or drying phase is too short.
Select a wash cycle with drying. → Page 10
▶
Some option buttons decrease the drying result.
Water collects in recesses of dishware or silverware.
Position dishware at an angle where possible.
▶
The combined detergent used has a poor drying performance.
Use rinse aid to improve drying performance.
1.
Use a different combined detergent with a better drying performance.
2.
Extra Dry/intensive drying not activated to improve drying performance.
Activate Extra Dry/intensive drying.
▶
Dishware removed too early or drying process not yet ended.
Wait until the program ends.
1.
Only remove dishware 30 minutes after the program has ended.
2.
Rinse aid used has a limited drying performance.
Use a name-brand rinse aid.
▶
Eco products may have limited effectiveness.
Silverware not arranged properly in the silverware basket or silverware drawer.
Droplets can form on the contact points of silverware.
Arrange silverware individually where possible. → Page 17
1.
Avoid points of contact.
2.
Not an error. Condensation drying creates water droplets in the tub. This is normal.
Moisture in the air condenses on the inside walls of the appliance, runs off, and is
pumped out.
No action required.