Bosch DISHWASHER Руководство по эксплуатации - Страница 25

Печатать страницу

Bosch DISHWASHER Руководство по эксплуатации

– After installing the appliance, ensure

that the plug is easily accessible.

(see Electrical connection)

– Some models:

The plastic housing on the water

connection contains an electric valve,

the connecting cables are in the supply

hose. Do not cut through this hose,

do not immerse the plastic

housing in water.

ã=

Warning

If the appliance is not in a cavity and a

side panel is accessible, the door hinge

area must be covered at the side

for reasons of safety (risk of injury).

The covers are available as optional

accessories from customer

service or specialist outlets.

Delivery

Your dishwasher has been checked

thoroughly in the factory to ensure that it is

in working order. This may cause small

water stains. These will disappear after the

first wash cycle.

Technical specifications

Weight:

max. 60 kg

Voltage:

220–240 V, 50 Hz or 60 Hz

Connected load:

2.0–2.4 kW

Fuse:

10/16 A (UK 13A)

Water pressure:

at least 0.05 MPa (0.5 bar), maximum

1 MPa (10 bar). At a higher water

pressure: connect pressure-reducing valve

ahead.

Inlet rate:

minimum 10 litres/minute

Water temperature:

cold water; hot water max. temperature

60 °C.

Installation

The required installation dimensions can

be found in the installation instructions.

Level the appliance with the aid of the

height-adjustable feet. Ensure that the

appliance is situated securely on the floor.

– A built-under or integrated appliance

which is installed subsequently as a

free-standing appliance must be

secured to prevent it from overturning,

e.g. by screwing it to the wall or by

installing it under a continuous worktop

which is screwed to adjacent

cupboards.

– The appliance can easily be

installed in a fitted kitchen between

wooden and plastic walls.

Waste-water connection

– The required work sequence can be

found in the installation instructions. If

required, fit a siphon with an drainage

connection.

– Connect the waste-water hose to the

drainage connection of the siphon with

the enclosed parts.

Ensure that the drainage hose is not

kinked, crushed or twisted and that

there is no cover plate in the drainage

to prevent the waste water from flowing

out!

Fresh water connection

– Connect the fresh-water connection to

the tap according to the installation

instructions with the enclosed parts.

Ensure that the fresh-water connection

is not kinked, crushed or twisted.

– When replacing the appliance, always

use a new water supply hose.