Bosch DISHWASHER Руководство по эксплуатации - Страница 14

Печатать страницу

Bosch DISHWASHER Руководство по эксплуатации

Washing the dishes

Programme data

The programme data (consumption

values) can be found in the summary of

instructions. They refer to normal

conditions and the water hardness set

value :

. Different influencing factors

such as e.g. water temperature or line

pressure may result in deviations.

Aqua sensor *

* depending on model

The Aqua sensor is an optical measuring

device (light barrier) which measures the

turbidity of the rinsing water.

The Aqua sensor is used according to the

programme. If the Aqua sensor is active,

"clean" rinsing water can be transferred to

the next rinse bath and water consumption

can be reduced by 3–6 litres. If the

turbidity is greater, the water is drained

and is replaced with fresh water. In the

automatic programmes the temperature

and running time can also be adjusted to

the degree of soiling.

Switching on the appliance

– Turn on the tap fully.

– Switch on ON/OFF switch (.

– Rotate programme selector 8 to the

required programme.

The expected programme duration

flashes on the digital display H.

– Press START button @.

The programme starts running.

Remaining running time display

When the programme is selected, the

remaining running time of the programme

is indicated on the digital display H.

The running time is determined during the

programme by the water temperature, the

number of utensils as well as the degree

of soiling and may vary (depending on the

selected programme).

Timer programming *

* depending on model

You can delay the start of the programme

in 1-hour steps up to 24 hours.

– Close the door.

– Switch on ON/OFF switch (.

– Press button P until the digital

display H jumps to :

– Press button P until the displayed

time corresponds with your

requirements.

– Press START button @, timer

programming is activated.

– To delete the preselected starting time,

press the button P until

indicated on the digital display.

You can change your programme

selection at any time until the

programme starts.

End of programme

The programme has ended when the

value :

is indicated on the numerical

display H.