Water Supply Shut Off Valve
Install an easily accessible shut-off valve (not supplied) in
the hot water supply line, as shown in Figure 7. All solder
connections must be made before the water line is connected
to the dishwasher.
Connecting the Hot Water Supply
There are two plastic corrugated hoses that exit the back of
end, is the water supply hose to the dishwasher (the other
hose is the dishwasher drain hose). You will need a 3" x 1
(76 x 45mm) opening through the cabinet to pass the dish-
washer water supply line through toward the shut off valve.
Water
Shut Off
Valve
To connect the hot water supply:
1. Assemble the water supply adaptor fitting from the
parts bag onto the dishwasher water supply hose. This
adaptor through the opening toward the water shut off
valve. Take care not to allow the hose to kink or twist
behind the dishwasher.
3. Connect the dishwasher water supply line with adaptor to
the water shut off valve. You will need to use an approved
this connection. Always use the appropriate seal when
making plumbing connections.
NOTE: The end of the dishwasher water inlet hose is
heavy and will need to be supported. It is best to lay the
4. After all connections are made, turn on the hot water and
check for leaks.
Dishwasher
Water Inlet
Hose
Figure 7
Figure 7.
The dishwasher drain hose may be connected to the house-
1
a 1
/
" diameter hole in order to pass the drain hose through
4
the cabinet.
1 Directly to the undersink dishwasher drain connection, as
shown in Figure 8.
2 Directly to a disposer dishwasher drain connection, as
shown in Figure 9.
3
/
"
3 To the undersink dishwasher drain connection through an
4
air gap, as shown in Figure 10.
4 To a disposer dishwasher drain connection through an air
gap, as shown on Figure 11.
IMPORTANT NOTES:
·
If local ordinance require an air gap, install it according
to the manufacturer's instructions.
·
If the dishwasher drain hose is to be connected to a
disposer dishwasher drain connection, remove the plug
from the disposer's dishwasher drain connection.
·
The dishwasher drain hose must have one place along
its length that is securely attached 20 inches above the
·
The drain hose length can be extended if necessary. The
maximum length of the drain hose, including the hose
leading to the air gap, is 150 inches.
Non-Metallic Tie
Figure 8
Figure 10
Drain Connections
Non-Metallic Tie
MIN.
20"
Figure 9
Figure 11
MIN.
20"
Remove
plug
9
Печатать страницу