Dramm FM20 Руководство пользователя - Страница 4
Просмотреть онлайн или скачать pdf Руководство пользователя для Пеногенератор Dramm FM20. Dramm FM20 16 страниц. Foamer
Также для Dramm FM20: Руководство пользователя (8 страниц)
Печатать страницу1. Always wear safety goggles and protective gloves while operating foam unit.
2. Avoid contact of cleaning agents with skin and eyes. If contact occurs rinse affected area with
water for 15 minutes and get medical attention if needed.
3. After use, relieve all remaining pressure in the system by unplugging the air line from the unit and
opening the discharge ball valve.
4. Incoming air pressure cannot exceed 100 psi.
5. Never point the discharge ball valve at anyone.
6. Be sure to flush the unit with fresh water for 5 minutes when switching from an alkaline to an
acid or an acid to an alkaline.
1. Remove all parts from shipping box.
2. Clip the cable tie holding the air fitting, cotter pins, and axle washers from the leg of the cart.
3. Place one of the washers on one of the axles, then slip a wheel on the axle followed by a second
washer, then insert a cotter pin into the hole in the axle and bend the cotter pin to keep it from
falling out. Repeat this for the other side.
4. Screw the air plug into the brass fitting on the side of the control box. Be sure to hold the brass
fitting while turning the air plug. Do not over–tighten.
Because there are a number of different air fitting standards available, Dramm foamers do not come
with a pre-installed air fitting. The air inlet offers both 1/4" female pipe thread and 3/4" male pipe
thread as connection options for your fitting.
1. Choose an air fitting that matches those on your compressor outlet.
2. Apply teflon tape or pipe sealant to the thread and install.
Foamer Manual
SAFETY INSTRUCTIONS
SET – UP INSTRUCTIONS
AIR FITTING
4