Bosch 300 Series Руководство по эксплуатации и уходу - Страница 5

Печатать страницу

Bosch 300 Series Руководство по эксплуатации и уходу

1. Troubleshooting

Operating Modes

You can use this appliance in the air extraction or the

recirculation mode.

Exhaust air mode

The air that is drawn in is cleaned by the

grease filters and conveyed to the

exterior by a pipe system.

Note: Ventilation may not exit through an already

operational smoke or exhaust chimney, nor a duct used

for ventilating furnace installation areas.

•

If the ventilation is intended to pass through a smoke

or exhaust chimney that is not in operation, the

responsible area heating inspector must give approval.

•

If the ventilation passes through an external wall, use a

telescope wall sleeve.

Operating the Appliance

These instructions apply to several appliance models. It

is possible that individual features are described that do

not apply to your appliance.

Note: Turn the extractor hood on when you start cooking

and switch it off again a few minutes after you have

finished cooking. This is the most effective way to

eliminate cooking vapor.

Control panel

Explanation

1 Turn the fan down

2 Turn the fan up

3 Display panel

Turn on the fan

Note: Always adjust the fan strength to meet current

conditions. If there is a large build-up of steam or fumes,

select a high fan setting.

Switching on

•

Press "+" button.

The current ventilator settings are indicated by a bar

on the display panel.

•

Press "+" or "-" keys to change the ventilator settings.

4 Switch on lighting

5 Timer

Circulating-air mode

The air that is drawn in is cleaned by the

grease filters and an activated carbon

filter and conveyed back into the kitchen.

Note: To bind odors in circulating-air mode, you must

install an activated carbon filter. The different options for

operating the appliance in circulating-air mode can be

found in the brochure. Alternatively, ask your dealer. The

required accessories are available for purchase from spe-

cialist retailers, from customer service or from the Online

Shop.

The accessory numbers can be found at the end of the

instructions for use.

Switching off

Press the "-" button repeatedly until the ventilator

switches off.

Lighting

The lighting can be switched on and off independently of

the ventilation.

1. Press the "Light" button.

The lighting switches on.

2. Press the "Light" button again.

The brightness increases.

3. Press the "Light" button a third time.

The lighting switches off.

Saturation notification

The saturation of the metal grease filter (after 30 hours of

ventilation operation) or of the activated carbon filter

(after 120 hours of ventilation operation) is indicated on

the display panel:

•

Metal grease filter: "clean grease filter" appears on

the display panel.

•

Activated carbon filter: "replace charcoal filter"

appears on the display panel.

If you have not yet done so, the metal mesh grease filters

should be cleaned or the activated carbon filter changed

now.

For instructions on how to clean the metal grease filters,

please refer to the Cleaning and maintenance section.

Page 5