Bosch 6 Series Руководство по эксплуатации и инструкции по установке - Страница 42

Печатать страницу

Bosch 6 Series Руководство по эксплуатации и инструкции по установке

Faults and what to do about them.

Faults

Water is leaking from the

machine.

Water not flowing in.

Detergent is not being dis-

pensed.

The door will not open.

The programme does not

start.

The drum briefly jerks or

judders after the pro-

gramme has started.

The water is not draining.

Water is not visible in the

drum.

The spin result is not sat-

isfactory.

Laundry wet/too damp.

The appliance restarts the

spin cycle several times.

The programme is taking

longer than usual.

The length of the pro-

gramme changes during

the wash cycle.

Water remaining in the

care product compart-

ment i.

Cause/remedy

Attach the drain hose correctly or replace it.

■

Tighten the threaded joint on the supply hose.

■

Will the programme start?

■

Is the tap turned on?

■

Could the filter be clogged? Clean the filter.~ Page 39

■

Is the supply hose kinked or trapped?

■

The safety function is active. Do you want to stop the programme?

■

~ Page 34

Have you selected $ (Rinse Stop = no final spin)? ~ Page 34

■

Can the door only be opened by the emergency release? ~ Page 40

■

When switching from a programme that uses active oxygen to one that

■

does not, the door will remain locked for up to 25 minutes until there is no

longer any active oxygen in the drum.

Have you started the programme or selected Finished in-time?

■

Is the door closed?

■

Is the childproof lock activated? Deactivate. ~ Page 33

■

Not a fault – the internal motor test may cause the drum to jerk or judder briefly

when the wash programme starts.

Have you selected $ (Rinse Stop = no final spin)? ~ Page 34

■

Clean the drain pump. ~ Page 38

■

Clean the drain pipe and/or the drain hose.

■

Not a fault – the water is below the visible area.

Not a fault – the unbalanced load detection system has interrupted the

■

spin cycle because the laundry is unevenly distributed.

Distribute small and large items of laundry evenly in the drum.

Is Easy-Iron selected? ~ Page 30

■

Is the selected speed too low?

■

Not a fault – the unbalanced load detection system is adjusting an imbalance.

Not a fault – the unbalanced load detection system is adjusting an imbal-

■

ance by repeatedly redistributing the laundry.

Not a fault – the foam detection system is active – a rinse cycle has been

■

activated.

Not a fault – the programme sequence is optimised for the specific washing

process. This may change the length of the programme shown on the display

panel.

Not a fault – the effectiveness of the care product is not affected.

■

Clean the insert if necessary.

■