Draper Acumen XL V Инструкции Установка и эксплуатация - Страница 4
Просмотреть онлайн или скачать pdf Инструкции Установка и эксплуатация для Проекционный экран Draper Acumen XL V. Draper Acumen XL V 12 страниц. Electric projection screen
Печатать страницу
Acumen
XL E & V
™
Section 5 - Hanging Screen
Section 5.1 - General:
1.
Wall Mounting Brackets
(minimum of 3) must be attached to the case regardless of mounting method.
2. Screen should be lifted into position only by case end caps. Keep case level by lifting case end caps simultaneously to prevent surface damage. Never attempt to
lift screen along its length.
3. When locating viewing surface and checking clearance for screen's operation, remember surface is centered in case. Handle case carefully to protect its finish.
4. Regardless of mounting method, screen should be positively and securely supported so that vibration or even abusive pulling on viewing surface will not cause
case to loosen or fall. Installer must ensure that fasteners used are of adequate strength and suitable for mounting surface chosen.
REFER TO DIAGRAM ON LAST PAGE OF MANUAL FOR WALL BRACKET DIMENSIONS
Section 5.2 - Wall Installation:
1. Secure the Mounting Brackets (minimum of 3) to the wall using appropriate hardware
See Fig. 4.
CAUTION: Product is very heavy: Installer must provide adequate attachment hardware and
anchors as required. Installer must also ensure that structure is of adequate strength.
2. Ensure that
mounting brackets
3. Slide all
Bracket Locks
to the center of case.
4. Holding the case by the endcaps, lift it up and over the cleats on the
. Wall Bracket Mounting Channels are shown in Fig. 5 below.
Fig.3)
5. Once the case is settled on the mounting brackets, slide the
12"
(305mm)
Max. Distance
Slide to lock case to
are level.
Figure 5-A
Bracket Locks
Bracket
(by others)
M o u n t
N O T E :
t o s e le
f o r t h e
mounting brackets
(see
Figure 5-B
ACUMEN XL
Wall
Mounting
Bracket
to the center of each
mounting bracket
One Wall Bracket
Centered
Wall Bracket Channels
Optional
for Case Mounting
Center Bracket
Appropriate hardware
provided by installer.
Wall Mounted
STUDS
16" (406mm) on center shown
W A L L
i n g H a
r d w a r e
It is t h e
(b y o th e
r e s p o n
r s )
c t m o u
s ib il it y
n t in g h
o f t h e in
a r d w a r
s t a ll e r
m o u n t in
e a p p r o
g s u r f a
p r ia t e
c e
SIDE VIEW
and secure set screw on the lock.
(see Fig. 6)
Slide to lock case to
Bracket
page 4 of 10
Appropriate
hardware
provided by
installer.
Ceiling Mounted
Figure 3
Figure 4
Figure 6