Draper FlexShade Инструкции по установке и эксплуатации - Страница 7

Просмотреть онлайн или скачать pdf Инструкции по установке и эксплуатации для Проекционный экран Draper FlexShade. Draper FlexShade 11 страниц. Exterior clutch-operated shade
Также для Draper FlexShade: Руководство по установке и эксплуатации (8 страниц), Инструкции по установке (2 страниц), Руководство по эксплуатации (12 страниц), Инструкции Установка и эксплуатация (12 страниц), Инструкции Установка и эксплуатация (16 страниц), Инструкции Установка и эксплуатация (4 страниц), Руководство по эксплуатации (7 страниц), Инструкции Установка и эксплуатация (12 страниц), Инструкции Установка и эксплуатация (16 страниц)

Печатать страницу
Draper FlexShade Инструкции по установке и эксплуатации
FlexShade
®

Section 9 - 5 Volt Motor Initial Setup

15 Channel Remote
Press right button for 1 second or less
to display current mode.
RESPONSE
LCD displays "L" when locked
LCD displays "U" when unlocked
1 Channel Remote
RESPONSE
LED solid on when locked
LED blinking when unlocked
P1 Button Functions
Motor state test: This table describes the function of a short P1 Button press/release
P1 Press
Condition
If limit is NOT set
Short
If limits are set
Press
If motor is in "Sleep
Mode" and limits are set
Activate Pairing Mode
Activate Pairing Mode
Approx.
Reset to Factory Settings
Approx.
Approx.
Approx.
Recharge
Function Achieved
None
Operational control of
motor, run to limit.
Stop if running.
Wake and control
Sleep Mode
Approx.
Approx.
Approx.
10
Select channel
Hold P1 button on
on controller.
motor head.
Motor Response
IMPORTANT
Consult user manual
for your controller
for information on
selecting channel.
Important: Motor is now in step mode and ready for setting limits.
depending on current motor configuration.
(<2 seconds)
Visual Feedback
Audible Feedback
No Action
None
Motor Runs
None
Motor wakes and
None
runs in a direction.
Hold STOP on
controller.
Must be done within 4 seconds
of motor jog from P1 button.
P1 BUTTON
Motor Response
Approx.
Function Described
No Action
Operational control of motor
after pairing and limit setting
is completed first time.
Motor is restored from Sleep
Mode and RF control is active.
Reverse Direction
Approx.
Approx.
page 7 of 11
Approx.
10