Draper FlexShade Инструкции Установка и эксплуатация - Страница 4

Печатать страницу

Draper FlexShade Инструкции Установка и эксплуатация

Cordless FlexShade

Section 4 - Adjusting Shade Tension

Please Note: If shade has too much tension

little

, tension level can be adjusted.

(does not reach the top)

1. Locate the acrylic tension or adjustment screws on shade's headrail.

2. If shade is in a metal valance, first remove the endcap on the valance.

3. If shade is in an upholstered valance, it may be necessary to first

remove the shade from the valance

Regular Roll:

Please Note: Adjustments can be made to the

screw to the LEFT hand side of shade.

1. Using a cross head or flat head screwdriver,

turn the screw until the desired tension is

reached.

2. Turning clockwise will LOWER the upper

limit.

3. Turning counter clockwise will RAISE the

upper limit.

Reverse Roll:

Please Note: Adjustments can be made on the

screw to the RIGHT hand side of shade.

1. Using a cross head or flat head screwdriver,

turn the screw until desired tension is

reached.

2. Turning clockwise will INCREASE tension.

3. Turning counter clockwise will DECREASE

tension.

or too

(springs up too quickly)

(Section 3)

Section 5 - Adjusting Shade Upper Limit

Please Note: Upon retracting shade, if it does not stop at a satisfactory

upper limit, the upper limit can be adjusted.

1. Locate the acrylic tension or adjustment screws on shade's headrail.

2. If shade is in a metal valance, first remove the endcap on the valance.

3. If shade is in an upholstered valance, it may be necessary to first

remove the shade from the valance

Regular Roll:

Please Note: Adjustments can be made to the

screw to the RIGHT hand side of shade.

1. Using a cross head or flat head screwdriver,

turn the screw until the desired tension is

reached.

2. Turning clockwise will LOWER the upper

limit.

3. Turning counter clockwise will RAISE the

upper limit.

Reverse Roll:

Please Note: Adjustments can be made on the

screw to the LEFT hand side of your shade.

1. Using a cross head or flat head screwdriver,

turn the screw until desired tension is

reached.

2. Turning clockwise will LOWER upper limit.

3. Turning counter clockwise will RAISE

upper limit.

page 4 of 4

(Section 3)