Draper Onyx Инструкции по сборке/монтажу
Просмотреть онлайн или скачать pdf Инструкции по сборке/монтажу для Проекционный экран Draper Onyx. Draper Onyx 2 страницы. Permanently tensioned projection screen
Также для Draper Onyx: Инструкции по сборке/монтажу (2 страниц), Инструкции по сборке/монтажу (2 страниц)
Печатать страницу
Onyx Permanently Tensioned Projection Screen by Draper
➀ Read instructions through completely before proceeding.
➁ Follow instructions carefully. Installation contrary to instructions
invalidates warranty.
➂ Screen should be accessible for complete removal should fabric
become damaged or should other service be required.
➃ Screen should be installed level (using a carpenter's level).
➄ Nothing should be fastened to screen frame or viewing surface.
➅ Make sure you have received all parts (see parts list below and
exploded diagram on page 2).
➆ Tools Required: Medium (#2) Phillips screwdriver (6" or greater shaft
length suggested). Optional tools: Flat blade screwdriver or small
putty knife.
NOTE: Screen has been thoroughly inspected and tested at factory and
found to be operating properly prior to shipment.
Onyx—Hardware and Parts List
Frame Extrusions - 4
Z-Brackets - 2
Surface Retention
Extrusions- 4
#10-24 fasteners - 8
Lag Bolts - 6
Frame Preparation
➀ Clean area and place frame assembly pieces face down. Insert plastic
corner pieces into ends of aluminum frame extrusions as indicated in
Figures 1 through 4. Secure each corner to each frame extrusion by
threading one #10-24 fastener through hole in plastic corner and into
rounded slot in aluminum frame extrusion.
Copyright © 2003 Draper Inc.
Assembly/Mounting Instructions
Caution
Frame Corners - 4
Plastic Tubing - 4
Viewing Surface - 1
Figure 1
Form Onyx_Inst03
➁ Secure corner pieces to aluminum frame extrusions with four (4) remaining
fasteners. Check to verify that all four (4) plastic corners are secure to
aluminum frame extrusion lengths and all eight (8) fasteners are tight (see
Fig. 5).
Please Note: It is not necessary to over-tighten fasteners.
If you encounter any difficulties installing or servicing your Onyx
screen, call your dealer or Draper, Inc., Spiceland, Indiana,
Printed in U.S.A.
(765) 987-7999; [email protected].
Figure 2
Figure 3
Figure 4
Figure 5
(Continued on Page 2)