Bosch WAA24160GB Инструкции по эксплуатации и установке - Страница 5

Просмотреть онлайн или скачать pdf Инструкции по эксплуатации и установке для Стиральная машина Bosch WAA24160GB. Bosch WAA24160GB 16 страниц.

Fixing the appliance

The appliance must be firmly fixed and

settled on its four feet, not rocking.

If necessary, level and stabilise the appliance us

ing the adjustable feet.

m Loosen the locknuts of the feet.

Connecting to the water supply (pic. 3)

The water inlet requires a cold water inlet pipe of

the type commonly used in homes (included; two

pipes in case of models featured for hot water),

with a minimum pressure of 1 bar.

If pressure is higher than 10 bar, a pressure-re

ducing valve must be inserted between the ap

pliance and the water supply.

The appliance should be connected to the

water supply using new feed pipes. The old

feed pipes should not be reused.

Do not connect the appliance to a mixer tap

without the pressure of a boiler! If in doubt,

you should get a specialist technician to as

semble and connect the appliance to the wa

ter inlet and outlet supplies.

m Correct the height of the feet.

m Securely tighten the locknuts so that the ad

justments made to the feet cannot be altered

accidentally.

Warning! The connections or couplings

between the appliance and the water supply

withstand the maximum pressure. Check

that the circuit is watertight by turning the tap

on fully!

Remove the filter at the end of the solenoid

valve in order to clean it (see «Cleaning / Mantei

nance / Frost protection»). The other filter, at

tached to the tap, should be cleaned in the

pipe itself (it is not detachable).

In order to prevent damage caused by water

leaks or flooding, the tap should always be

turned off after the appliance has completed

its work cycles and during lengthy periods of

inactivity.

Only tighten the plastic locknuts of the pipe's

connections by hand.