Bosch WAE 16261 Руководство по эксплуатации - Страница 2
Просмотреть онлайн или скачать pdf Руководство по эксплуатации для Стиральная машина Bosch WAE 16261. Bosch WAE 16261 8 страниц.
Safety instructions
– Read the instruction manual and installation instructions and all other information enclosed
with the washing machine and act accordingly.
– Retain the documents for subsequent use.
Risk of electric shock
Danger to life
Danger of suffocation
Risk of poisoning
Risk of explosion
Risk of injury
Consumption values
Programme
(Cottons) 30 °C**
(Cottons) 40 °C**
(Cottons) 60 °C**
(Cottons)
(Cottons) 90 °C
(Easy-care) 40 °C**
/C
/
/
(Wool) 30 °C
* Programme setting for testing and energy labelling in accordance with EU directive 92/75/EEC.
** Programme setting for testing in accordance with valid standard EN60456.
Note on comparative tests: For testing the test programmes, wash the specified load using the maximum spin speed.
As a short programme for coloureds, select the programme
the maximum spin speed.
*** The values deviate from the indicated values depending on water pressure, hardness, and inlet temperature, ambient
temperature, type, amount and soiling of the laundry, detergent used, fluctuations in the power supply and selected
Downloaded From WashingMachine-Manual.com Manuals
additional functions.
7
Care
Before washing for the first time
Do not load any laundry into the machine. Turn on the tap. Add the following to compartment
II:
– Never pull the cable to disconnect the mains plug.
– approx. 1 litre water
– detergent (dosage according to the manufacturer's instructions for light soiling and the
– Never insert/disconnect the mains plug with damp hands.
appropriate degree of water hardness)
For worn-out appliances:
Set the programme selector to
– Disconnect the mains plug.
At the end of the programme, turn the programme selector to
– Sever the mains cable and discard along with the plug.
Machine housing, control panel
– Destroy the lock on the washing machine door. This will prevent
children from locking themselves in and risking their lives.
– Wipe with a soft, damp cloth.
– Do not use any abrasive cloths, scourers or cleaning agents (stainless steel cleaners).
– Keep packaging, film and packaging parts out of the reach of
– Remove detergent and cleaning agent residue immediately.
children.
– Do not clean with a jet of water.
– Keep detergents and care products out of the reach of children.
Cleaning the detergent drawer ...
– Items of laundry pretreated with cleaning agents containing
... if it contains detergent or fabric softener residues.
solvents, e.g. stain remover/cleaning solvent may cause an
explosion after being loaded into the washing machine.
1. Pull out, press insert down, remove drawer completely.
Rinse items of laundry thoroughly by hand beforehand.
– The washing machine door can become very hot.
– Be careful when draining hot detergent solution.
2. To remove the insert: press the insert upwards from below with your
– Do not climb onto the washing machine.
finger.
3. Clean the detergent dispenser tray and insert with water and a brush and
– Do not lean on the open washing machine door.
dry it.
– Do not reach into the drum if it is still rotating.
4. Attach the insert and engage (connect the cylinder to the guide pin).
– Be careful when opening the detergent drawer while the machine
5. Push in the detergent drawer.
is in operation.
Leave the detergent drawer open so that any residual water can
evaporate.
Drum
Electricity
Programme
Load
Water***
consumption***
duration***
Leave the washing machine door open so that the drum can dry out.
Rust stains - use chlorine-free cleaning agent, not steel wool.
6 kg
0.51 kWh
55 l
2:21 h
Descaling
6 kg
0.63 kWh
55 l
2:21 h
Descale the appliance according to the descaler manufacturer's instructions. This should not
6 kg
1.26 kWh
55 l
2:29 h
be necessary if the correct dosage of detergent is used.
EcoPerfect 60 °C*
6 kg
1.02 kWh
45 l
2:49 h
6 kg
1.98 kWh
59 l
2:34 h
Information on the display panel
3 kg
0.55 kWh
55 l
1:37 h
E3
Close the washing machine door properly; laundry may be caught.
. (Quick/Mixed fabrics) 40 °C**
3 kg
0.48 kWh
32 l
1:03 h
E5
Open the tap completely, supply hose kinked or trapped;
,
(Delicates/Silk cold)
2 kg
0.06 kWh
31 l
0:41 h
Clean the filter –> page 10, Water pressure too low.
(Delicates/Silk) 30 °C
2 kg
0.21 kWh
31 l
0:41 h
E6
Detergent solution pump blocked; Clean the detergent solution pump –> page 10.
Drainage hose/waste pipe blocked; Clean the drainage hose at the siphon –> page 10.
(Wool cold)
2 kg
0.10 kWh
39 l
0:40 h
E2
Motor fault. Call the after-sales service.
2 kg
0.19 kWh
39 l
0:40 h
/C
. (Quick/Mixed fabrics) 40 °C with
8
8
– Risk of electric shock.
Maintenance
Disconnect the mains plug.
– Risk of explosion. No solvents.
Detergent solution pump
Turn the programme selector to
. (Off) and disconnect the mains
plug.
1. Open and remove the service flap.
(Easy-Care) 60 °C and select
(Start/Pause).
. (OFF).
2. For models with a drainage hose: Remove the drainage hose from the
retainer and pull it from the housing. Remove the container.
Remove the sealing cap, allow the detergent solution to flow out.
Replace the sealing cap and place the drainage hose in the retainer.
2* For models without a drainage hose: Carefully unscrew the pump cover
until the detergent solution begins to flow out. When the service flap is
half full, close the pump cover and empty the service flap. Repeat the
above steps until all the detergent solution has completely drained out.
3. Carefully unscrew the pump cover (residual water).
4. Clean the interior, pump cover thread and pump housing (the impeller in
the detergent solution pump must rotate).
5. Replace the pump cover and screw it tightly.
6. Place the service flap back on and close.
To prevent unused detergent from flowing straight into the drain during the next wash:
Pour 1 litre of water into compartment II and start the
Drainage hose at the siphon
Turn the programme selector to
.(Off) and disconnect the mains plug.
1. Loosen the hose clamp, carefully remove the drainage hose
(residual water).
2. Clean the drainage hose and siphon connecting piece.
3. Reattach the drainage hose and secure the connection with the hose
Ensure there is no laundry in the machine
clamp.
Filter in the water supply
Risk of electric shock
Do not immerse the HydroSafe safety device in water (contains an electric valve).
depending on model
Reduce the water pressure in the supply hose:
1. Turn off the tap.
2. Select any programme (except
Spin/Drain)).
3. Select
(Start/Pause). Let the programme run for approximately 40
seconds.
4. Turn the programme selector to
. (Off). Disconnect the mains plug.
Clean the filter:
1. Depending on model:
Disconnect the hose from the tap.
Clean the filter using a small brush.
and/or for Standard and HydroSafe models:
Remove the hose on the rear of the appliance,
Remove the filter with pliers and clean.
9
2. Connect the hose and check for leaks.
– Risk of scalding. Allow the
detergent solution to cool down.
What to do if ...
– Turn off the tap.
Water is leaking out.
– Attach/replace the drainage hose correctly.
– Tighten the screw connection of the supply hose.
No water supply.
–
(Start/Pause) not selected?
Detergent not dispensed.
– Tap not turned on?
– Filter blocked? Clean the filter –> page 10.
– Supply hose kinked or trapped?
Washing machine door
– Safety function active. Wait approx. 2 minutes.
cannot be opened.
– - - - - (without final spin) selected? –> page 3, 4.
Programme does not
–
(Start/Pause) or
(Finished in-time) selected?
start.
– Washing machine door closed?
– Childproof lock active? Deactivate –> page 5.
Detergent solution is not
– - - - - (without final spin) selected? –> page 3, 4.
drained.
– Clean the detergent solution pump –> page 10.
– Clean the waste pipe and/or drainage hose.
Water not visible in the
– Not a fault - water below the visible area.
drum.
Unsatisfactory spin result.
– Not a fault - the unbalanced-load detection system has cancelled
Laundry wet/too damp.
the spin cycle because of uneven distribution of the laundry.
Distribute small and large items of laundry evenly inside the drum.
– Programme
(Easy iron) selected? –> page 7.
– Selected speed too low?
page 5.
The programme length
– Not a fault - the number of spin cycles may be changed due to the
jumps during the final
varying distribution of the laundry, which may cause the time in the
spin..
display panel to be corrected.
Spin cycle performed
– Not a fault - unbalanced load detection system adjusts the
(Drain) programme.
several times.
imbalance.
Residual water in the
– Not a fault - the action of the care product is not affected.
compartment for care
– Clean the insert if necessary –> page 9.
products.
Odour formation in the
– Run programme
(Cottons) 90 °C without laundry. Use
washing machine.
standard detergent.
Foam escaping from the
– Too much detergent used?
detergent drawer.
If foam is escaping from the detergent drawer:
Mix 1 tablespoon of fabric softener with ½ litre of water and pour
into compartment II (not with outdoor or down fabrics).
– Reduce the detergent dosage for the next wash cycle.
Intense noise formation,
– Are the appliance feet fixed?
vibrations and
Secure the appliance feet –> Installation instructions.
"wandering" during the
– Transportation safety devices removed?
spin cycle.
Remove the transportation safety devices –> Installation
instructions.
Display panel/indicator
– Power cut?
/
/
(Rinse/
lamps do not function
– Fuses triggered? Reset/change the fuses.
during operation.
– If the fault occurs repeatedly, call the after-sales service.
Programme sequence
– Not a fault - unbalanced load detection system adjusts imbalance
longer than usual.
by repeatedly distributing the laundry.
– Not a fault - foam detection system active - adds an additional
rinse cycle.
Detergent residues on the
– Occasionally, phosphate-free detergents contain water-insoluble
laundry.
residues.
– Select
/
/
(Rinse/Spin) or brush the laundry
after washing.
If you cannot correct a fault yourself (switching on/off) or a repair is required:
– Turn the programme selector to
. (Off) and remove the mains plug from the socket.
– Turn off the water supply and call the after-sales service –> Installation instructions.
10
Washing machine
Instruction manual
en
Observe the safety instructions on page 8.
Read these instructions and the separate installation instructions
before operating the washing machine.
11