Bosch WAE24060 Руководство по эксплуатации - Страница 8
Просмотреть онлайн или скачать pdf Руководство по эксплуатации для Стиральная машина Bosch WAE24060. Bosch WAE24060 8 страниц. Bosch washing machine instruction manual
What to do if ...
Water is leaking out.
– Attach/replace the drainage hose correctly.
– Tighten the screw connection of the supply hose.
– Start not selected?
No water supply.
Detergent not dispensed.
– Tap not turned on?
– Filter blocked? Clean the filter
– Supply hose kinked or trapped?
Washing machine door
– Safety function active. Wait approx. 2 minutes.
cannot be opened.
Programme does not start.
– Start selected?
– Washing machine door closed?
Detergent solution is not
– Clean the detergent solution pump
drained.
– Clean the waste pipe and/or drainage hose.
Water not visible in the drum. – Not a fault - water below the visible area.
Unsatisfactory spin result.
– Not a fault - the unbalanced-load detection system has cancelled the spin
Laundry wet/too damp.
cycle because of uneven distribution of the laundry.
Distribute small and large items of laundry evenly inside the drum.
Spin cycle performed several
– Not a fault - unbalanced load detection system adjusts the imbalance.
times.
Residual water in the
– Not a fault - the action of the care product is not affected.
compartment for care
– Clean the insert if necessary
products.
Odour formation in the
– Run programme Cottons 90 °C without laundry. Use standard detergent.
washing machine.
Foam escaping from the
– Too much detergent used?
detergent drawer.
If foam is escaping from the detergent drawer:
Mix 1 tablespoon of fabric softener with ½ litre of water and pour into
compartment II (not with outdoor or down fabrics).
– Reduce the detergent dosage for the next wash cycle.
Intense noise formation,
– Are the appliance feet fixed?
vibrations and "walking"
Secure the appliance feet
during the spin cycle.
– Transportation safety devices removed?
Remove the transportation safety devices
Noises during spin and drain
– Clean detergent-solution pump
cycles.
The indicator lights do not
– Power cut?
function during operation.
– Fuses tripped? Reset/change the fuse.
– If the fault occurs repeatedly, call the after-sales service.
Programme sequence longer
– Not a fault - unbalanced load detection system adjusts imbalance by
than usual.
repeatedly distributing the laundry.
– Not a fault - foam detection system active - adds an additional rinse cycle.
Detergent residues on the
– Occasionally, phosphate-free detergents contain water-insoluble residues.
laundry.
– Select Rinse or brush out the laundry after washing.
If you cannot correct a fault yourself (switching on/off) or a repair is required:
– Turn the programme selector to Off and remove the mains plug from the socket.
– Turn off the water supply and call the after-sales service
page 10.
page 10.
page 9.
Installation instructions.
Installation instructions.
page 10
Installation instructions.
11
Washing machine
en Instruction manual