Draper 19392 Руководство - Страница 12

Просмотреть онлайн или скачать pdf Руководство для Электроинструмент Draper 19392. Draper 19392 20 страниц. 12v oscillating multi-tool

Печатать страницу

7. Preparing the Multi-tool

WARNING! ALWAYS ensure that the on/off switch is in

the off ( ) position and the battery pack is removed

before preparing or making any adjustments to the

tool.

7.1 Installing and Removing the Battery

Pack

Important: ONLY use this tool with battery packs and

chargers from the Draper Tools 12V range. Read all of the

safety and operation instructions provided with these

parts before use.

Fig.

• To install a battery pack (9), insert it into the socket at

the base of the multi-tool until it clicks into place.

Important: Do not force the battery, and ensure it is

firmly secure before use.

• To remove a battery pack, press and hold the battery

release buttons (8) on either side of the battery pack

and slide the battery away from the tool.

Important: The tool will automatically power down if the

battery voltage drops too low or overheats. DO NOT use

the tool until the battery pack has been charged or

cooled as appropriate.

(8)

(9)

7.2 Charging the Battery

Important: ALWAYS ensure that the voltage of the

power source is the same as the voltage specified on the

rating plate of the charger before connecting the charger

to the power supply.

(I.1)

(I.2)

Fig.

1. Connect the charger (I) to a mains power supply; the

green LED (I.2) will flash to indicated standby mode.

2. Insert the battery pack into the charger socket (H);

the red LED (I.1) will illuminate to indicate charging.

3. When the battery is charged, the red LED will go out

and the green LED will illuminate.

4. Unplug the charger from the power supply and

remove the battery from the charger.

Important: For a longer battery lifespan, charge the

battery pack in ambient temperatures of 18–24°C. DO

NOT charge the battery in temperatures greater than

40°C or less than 5°C. If the battery pack is not at an

acceptable temperature when inserted into the charger,

both LEDs will flash alternately and the battery will not

charge until it has reached the required temperature.

The charger LEDs illuminate in the following modes:

• Green flashing: The charger is in standby mode.

• Solid green: Charging is complete.

• Red flashing: The battery pack is faulty or damaged

and cannot be charged.

• Solid red: The battery is charging.

• Green and red flashing alternately: The battery pack

is either too hot or too cold; charging will begin when

an acceptable temperature is reached.

– 12 –

(H)

(I)