Draper 14602 Руководство по эксплуатации - Страница 11

Просмотреть онлайн или скачать pdf Руководство по эксплуатации для Сверло Draper 14602. Draper 14602 20 страниц. 18v li-ion cordless hammer drill

BASIC CORDLESS HAMMER DRILL OPERATIONS

8.1 BATTERY CHARGING – FIGS. 1 - 2

(i) To release the battery pack

the battery release button

front of the battery pack and gently pull the

battery pack away from the housing (Fig.1).

(ii) Slide the battery pack

down, onto the corresponding connection of

the charger

plug into a 230V electrical socket.

(iii) Do not force, ensure the battery is inserted

correctly. The green LED

will now flash to show that the battery is

charging.

The battery will be fully charged after the 1 hour

charging period and the green LED will illuminate

solid.

A flashing red LED

is too hot, or is defective. Allow the battery pack to

cool, then attempt re-connection.

The battery pack can then be removed.

To refit the battery pack to the drill, push firmly until

the battery pack locates and clips into place.

Warning: Do not exceed charging period this could

damage the battery. Overcharging the battery (more

than six hours) could damage the battery cells.

Note: The battery was discharged after manufacturing and will therefore require five to ten

charges/discharges before it reaches its full capacity.

Do not expose either the drill or charger to rain or water.

8.2 DUST AND SWARF

A correctly fitted dust mask, suitable for the activity and in accordance to the relevant

standard must be worn.

Swarf produced by metal drilling is extremely sharp. Take precautions when clearing swarf.

The burr left on the hole is also sharp and should be removed with a suitable tool.

Always wear safety goggles.

Warning: Drill bit will be hot after use.

, press down on

located on the

, connection side

, then the charger's three pin

on the charger

indicates that the battery pack

FIG.1

FIG.2