Draper CHD12V2 Руководство по эксплуатации - Страница 11

Просмотреть онлайн или скачать pdf Руководство по эксплуатации для Сверло Draper CHD12V2. Draper CHD12V2 13 страниц.

DRILLING WOOD AND PLASTIC

To prevent splitting around the drill holes on the reverse side, place a piece of scrap

timber under the material to be drilled.

DRILLING MASONRY

Start drilling at a low speed to prevent the drill bit from wandering. Once penetration is

achieved fully depress the trigger to achieve maximum speed and hammer power.

DRILLING METAL

Metals such as sheet steel, aluminium and brass may be drilled. Mark the point to be

drilled with a centre punch to help the drill bit tip to locate.

SCREWDRIVING

To prevent slip or damage to the screwhead, match the screwdriver bit to the

screwhead size. To remove screws move the direction switch to the reversing position

and apply pressure to the screwhead and depress the trigger slowly.

MAINTENANCE

Neither the drill or charger require any special maintenance.

Keep both the drill and the charger in a dry place where they will not be exposed to

frost or direct sunlight.

STOCK Nos.:

54451

54452

54453

57808

57809

IMPORTANT:

POWER DIVISION HELPLINE: ( 023 ) 8049 4344

OPERATION cont'd ...

BATTERIES

PART Nos.:

CB96

CB12

CB14

CB14A

CB18

Please note all repairs/adjustments

should be carried out by a qualified person.

- 10 -

VOLTAGES

9.6V

12V

14.4V

14.4V (2.0AH)

18V (2.0AH)