Draper MBS46A Руководство по эксплуатации - Страница 11
Просмотреть онлайн или скачать pdf Руководство по эксплуатации для Пила Draper MBS46A. Draper MBS46A 16 страниц. Horizontal and vertical metal cutting bandsaw
Печатать страницу
10. CUTTING FEED PRESSURE
ADJUSTMENT (Fig.12)
Depending on the material being cut
the cutting pressure needs to be
adjusted. NOTE: The harder the
materials, the slower the cutting speed
should be. When viewed from the
handle end, turning the handle ✽✌
clockwise, tensions the spring ✾✌
making the head lighter and
producing a slower cut. Anticlockwise
has the opposite effect. It should only
be adjusted one turn at a time.
11. CUTTING OPERATIONS
(Fig.13.)
To clamp work pieces with the vice
✿✌. To clamp turn the handle wheel
❀✌ clock-wise until tight. To carry out
bevel cuts simply loosen the bolts
holding the jaws and turn to the
required angle, then retighten the
bolts. To repeatedly cut the same
length set up the end stop ❀✌ to
touch the end of the work piece.
Adjustment is carried out with the hex
key supplied.
12. HEAD REST (Fig.13)
To avoid continual raising of the head
to its full up right position when
making adjustments, the head rest ❂✌
slots into the cutouts in the head. To
release, simply lift the head slightly
and the rest will fall away.
OPERATION & USE
✾✌
❀✌
❁✌
FIG.13.
- 10 -
FIG.12.
✽✌
✿✌
❂✌