Draper 02519 Руководство - Страница 14

Просмотреть онлайн или скачать pdf Руководство для Шлифовальный станок Draper 02519. Draper 02519 20 страниц. 230v router
Также для Draper 02519: Руководство (20 страниц)

Печатать страницу

BASIC ROUTER OPERATIONS

Note: Remove the plug from the socket before

carrying out adjustment, servicing or maintenance.

9.1

TRIGGER SWITCH – FIG. 5

The router is fitted with a safety lock off switch to

prevent accidental starting. Press and hold lock

button (2). Pull trigger (1) and the router will start.

9.2

VARIABLE SPEED DIAL – FIG. 6

•

Stock No.02519

The variable speed dial is marked 1 to MAX and

corresponds to the table below:

Setting

MAX

Note: Cutting speed depends on material, cutter

size, cutting depth etc. Larger router bits will

require a slower speed. For more detailed

information refer to routing/woodworking reference

material.

9.3

SETTING THE CUTTING DEPTH –

FIGS. 7 – 8

− With a suitable router bit fitted place the router

on to the workpiece. Rotate the turret (8) to the

lowest position. Slowly plunge the router until

the bit just touches the workpiece. Lock the

router in this position with the plunge lock lever

(3).

− Ensure the depth guide locking screw (6) is not

tight and lower the rod (6.1) until it touches the

turret. If necessary turn the fine height

adjustment control (5) to align the nearest digit

on the scale against the pointer (6.2).

− Take note of the setting before raising the rod

upward to set the plunge depth (the difference

between the two measurements) and securely

tighten the depth guide locking screw (6).

Example: The scale reads 23. After adjustment

reads 33 – the plunge depth will be 10mm.

Speed

Low speed

Medium speed

High speed

– 14 –

(1)

FIG.

Stock No. 02520

(5)

(6.2)

(6)

(6.1)

Stock No. 02519

(8)

FIG.

(2)