Draper FlexShade 2 Pocket Headbox Руководство по эксплуатации - Страница 5

Просмотреть онлайн или скачать pdf Руководство по эксплуатации для Внутренняя отделка Draper FlexShade 2 Pocket Headbox. Draper FlexShade 2 Pocket Headbox 8 страниц. Maximized coverage for large, tall areas, while also reducing light gap

Печатать страницу

FlexShade

Section 4 - Bottom Closure Removal/Replacement

Please Note: Removal and replacement of the bottom closure panel requires two people positioned about 5' from each end of the panel.

Closure should be handled as shown in Step 5 to prevent bowing of the closure during handling.

Step 1

CAUTION: Before

removing bottom

closure, you must first

remove screws at each

end of case

(see drawing)

Screw and

Washer

Step 3

Section 5 - Operation

Section 2.1 - Adjustments

Caution: Be sure all switches are in "off" position before adjusting limit switches. Always be prepared to shut shade off manually when new adjustment is being

tested. Shade may be severely damaged if allowed to run too far up or too far down.

ADJUSTING "FULLY UP" POSITION—Put a small screw driver in the groove of the yellow button on the motor and press vertically until hearing a "click". Raise the

shade by pressing the "up" switch on unit. Press the "stop" switch when the shade is at the desired position. Then press the yellow button on motor until you hear a

"click", then release.

ADJUSTING "FULLY DOWN" POSITION—Put a small screw driver in the groove of the white button on the motor and press vertically until hearing a

"click". Lower the shade by pressing the "down" switch on unit. Press the "stop" switch when the shade is at the desired position. Then press the white button on motor

until you hear a "click", then release.

AT NO TIME SHOULD SHADE BE UNROLLED ENOUGH TO EXPOSE ANY PART OF SHADE ROLLER.

Please Note: The above instructions affect only the limits on standard motors. For adjustment procedures using RTS, RS485, or Draper's IntelliFlex I/O Control

Systems, please consult the installation information on the Draper

2 Pocket Headbox

Step 2

Step 4

website for the appropriate control.

page 5 of 8

Step 5

CAUTION:

Be sure to replace

screws and washers

at each end of case

when replacing

closure!

(see drawing)