Bottom-Up FlexShade
Small and Large Hardware
Section 7 - Bottom Roller Assembly
1. Slide the Bottom Roller Assembly into the brackets, spear-end first
WARNING: The triangular shaped arrow on the end of the device MUST be pointing UP when installed
will not "lock" during operation. Raising the hem bar approximately 1/4-turn will "un-lock" the device, providing constant tension on the fabric panel.
Please Note: Ensure that the hem bar cannot move
2. Install the cotter pin through the fabric roller idler bracket to secure the roller
Section 8 - Installing Draw Cables
Warning: Do NOT trim draw cables until Section 9, Step 10.
Caution: Starting locations of the Cable Attachment Studs are provided by Draper
shade. Although these locations can be adjusted, the installer must ensure that any
adjustments do not cause the hem bar to run into the brackets, possibly damaging the unit.
1. Carefully pull one end of the draw cable through one of the Draw Cable Pulleys, then behind
the Take-Up roller.
2. Wrap the cable 1 1/2 revolutions around the tube.
3. Grip the end of the draw cable between the Cable
Attachment Stud and roller tube, then tighten the
Cable Attachment Stud.
4. Pull the other side of the draw cable through remaining
Draw Cable Pulley, then behind the Take-Up roller.
5. Pull the hem bar up so that the fabric retraction device
"unlocks."
Warning: DO NOT allow Hem Bar to move around
the roller.
Please Note: Both ends of Draw Cable must have 1½
revolutions around the operator roller when the hem bar
is at its lowest possible position.
NEXD,
®
.
(Fig. 7-A)
around the roller until the installation is complete.
(counterclockwise)
(Fig. 7-B)
Figure 7-A
(Section 5, Fig. 5-A)
. Bend one leg of the cotter pin down to lock it into place.
Figure 7-B
with each
®
Figure 8
2
3
1
page 6 of 10
to ensure that the mechanism
4
5
Печатать страницу