Dual Roller FlexShade
Section 1 - Mounting Endcaps
Please Note: If installing Pocket Headbox or Surface Headbox, please install headbox FIRST
Caution: Before mounting shades, verify measurements on label provided with shade, and ensure unit is installed at correct width.
Please Note: Installer is responsible for selecting mounting hardware appropriate for site conditions.
1. Mark surface for placement of endcaps.
2. Drill small starter hole
(if necessary)
3. Snap endcap covers onto endcaps
Please Note: If endcap covers have been provided with
the shade order, they are included in the width of the
shade measurement and must be used.
CAUTION:
If installing without a headbox, proceed to Figure 2,
below, NOW.
If installing with a Dual Roller Pocket Headbox,
proceed to Section 2 NOW.
If installing with a Dual Roller Ceiling/Wall
Headbox, proceed to Section 3 NOW.
5. Mount endcaps using appropriate fasteners for surface
.
(Fig. 2)
CEILING MOUNTING
Figure 2-A
Mount endcaps
to ceiling.
JAMB MOUNTING
Figure 2-C
PLEASE NOTE:
If endcap covers are included in order,
drill through endcap cover and secure with endcap.
Endcap requires a minimum of two fasteners.
It is not necessary to utilize all corners.
NEXD
®
in mounting surface.
.
(Fig. 1)
Mount
endcaps
to jamb.
.
(Section 2, Section 3)
Snap endcap
covers
into place.
Figure 1
WALL MOUNTING
Figure 2-B
Mount endcaps
to wall.
B
A
Please Note: If installing shade or shades in an area
where misuse is likely, this fastening method should
be used.
page 3 of 12
E N D
C A P
C O V
E R
please note
Endcaps must be fastened securely
to mounting surface and cannot
move from side to side.
If changes, differences, or
measurement errors occur on-site,
adjust product by utilizing slotted
holes in the endcap [A] to adjust for
zero gap between the fascia and
endcap covers.
Once these adjustments are made,
utilize round holes [B] to drive
additional screws for securing
position.
Печатать страницу